Every pool must turn over at least once a day, so most pool pumps should run approximately 8 hours a day. But here's the thing: you don't have to run your pool pump consecutively. You can choose to run it for three hours in the morning before you leave for work and another 5 hours in the evening.
Reviewing Recirculation
This setting is used infrequently, but is helpful when you want to mix newly added pool chemicals or when you need to keep the pool water moving while you perform filter repairs.
The rule of thumb is generally 8 hours, although it could be anywhere from 6-12 hours, depending on your pool's size. Each pool is unique, so to keep your pool pump efficient and effective, you need to figure out exactly what your pool's turnover rate is.
It's best to run your pool pump during the day
Not only does sunlight give fuel for algae to grow, it also destroys your pool chlorine and this is why you should always run your pool during the day!
Chemicals that you add to your pool while the water is circulating don't need to be recirculated; they will stay mixed even if you don't pump the water continually. Although it's generally recommended that all the pool water undergo filtration every 24 hours, the pump does not need to run all the time.
One of the most significant consumers of energy in homes with swimming pools are pool pumps, which keep pools clean by circulating water through filters. Pool pumps can consume 3,000 to over 5,000 kWh per year.
Depending on the size of your pool, we still recommend you run your pump run at least 4-6 hours a day during the fall and winter months. The daily cycle can be divided into multiple cycles, but each cycle should be no shorter than 4 hours, for all the water to pass through the filter at least once.
You cannot run your pool pump every other day because the standing water can pose a health risk as it can quickly accumulate bacteria and fungi. It is crucial to run the pump every day for 8 hours (in one or multiple sessions), so the entirety of the pool's contents run through the filter once.
The size of your pool, the efficiency of your pump and filter, and how dirty your pool is are just some of the factors you need to consider. Nevertheless, most pool cleaning professionals would advise against running a pool pump for more than 8 hours a day.
You should run your pump/filter as long as it takes to keep the pool clean. Some pools have great circulation combined with low use, therefore run times can be quite short. Other pools have lousy circ systems and huge bather loads and even 24/7 filtration has trouble keeping up.
Run the filtration system
While shocking your pool will help kill any germs any algae, it won't actually get rid of them; for that, you need your filter. So be sure to run your pool filter for at least 24 hours.
After the hose fills with water, backwash your sand filter for 2 - 3 minutes, or until water runs clear. Shut off the pump motor and push the T-handle back down into locked position. Turn your pump back on and note the lower pressure.
Heat transfer efficiency is higher with higher flow rates. However, you have to look at total efficiency and cost. It may be worth the extra heat loss to run the pump at lower speeds.
The extra filtering will help clean out the impurities rain has introduced into your pool's water. Pool pumps are made to withstand rain and it is beneficial to run your pump during or after rain.
Run your filter pump for at least 12 hours a day, every day. This will make sure all the water in your pool circulates at least once. In an ideal world of bottomless money vaults, you could run your pool pump 24 hours a day, but 12 hours is a good compromise.
Even if you have your pool covered, some debris may still get in it during the winter. For this reason, you should consider running your pump on occasion whenever the outdoor temperature is between 35 and 65 degrees. Around four to six hours should be sufficient to remove debris and help promote good circulation.
Is It Safe To Run The pool Pump With The Pool Cover On? It is safe to run the pool pump and filter with a swimming pool cover on. The pool cover doesn't in any way stop or hinder the pool pump from circulating the water or carrying out its function.
If you have an above ground pool with the pool filter system and plumbing above ground (like nearly all above ground pools), pipes and pumps can freeze up in less than an hour of minus 32 degrees. The same is true for inground pool equipment that is not running when temperatures are below freezing.
Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time. Residential pool water only needs to be turned over once daily to have proper filtration.
So if you have to leave it running for a week it shouldn't make a big dent in the electric bill. Having to spend the money on getting the pool back in shape will probably cost more than leaving it on anyway. I would make sure you fill the pool water as high as you can though since you will be gone for a week.
Portable household generators are normally 110V but there are some that will generate 240V. Most pool pumps are wired 240V in this market. Adapting the wiring to hook up a 240V generator to a pool pump should be done by an electrician only. This is a very uncommon practice.
Depending on how much you have added and the size of your pool, it is generally safe to wait about 4 hours after adding liquid chlorine or until levels reach 5 ppm or lower.