Fill a bucket with hot water. Carefully pour the hot water into the toilet to dissolve the liquid, bar soap or baking soda.
Moving water, preferably hot. If you can get a small flow that doesn't back up then it will dissolve away easily. Baking soda and vinegar, it will clean almost any small clog. With something that dissolves easily like soap, the extra air bubbles produced will help getting it clean with less passes as well.
Soap dissolves faster when water is in motion. If you used a pot, you can place it on the stove on the lowest heat setting. The heat causes the soap to dissolve instantly because of the soap's fat content.
As it turns out, you can actually unclog a toilet with dish soap instead of turning to a harsh, toxic bowl cleaner. Just as natural dish soap helps break down dirt, grease, and food that may be stuck on dishes and utensils, it can help break down what's in your toilet bowl.
“Vinegar is a good cleaner because it's acidic, but when you add dishwashing liquid/dish soap to it (which is a base or neutral) - you neutralise the vinegar. You take away the very thing that makes it work well. “The dishwashing liquid works that well on its own. Adding the vinegar is a pointless step.”
Pour Hot Water into the Toilet
If you need to heat some in the microwave or the stovetop, you don't want it to reach boiling temperatures. Boiling water can cause toilet porcelain to crack. Allow the hot fluid to sit in the toilet for a few minutes to loosen the clog.
Drano Liquid Drain Cleaner flushes clogs away quickly. It works great to remove hair, soap scum, and other gunky clogs.
Just like cleaning products, Coke has a low PH level (3.4) and similar to lemons, includes citric acid (which can remove alkaline substances, like soap scum) in its makeup.
So when you spritz alcohol onto bubbles at the surface of MP soap, the soap dissolves in the alcohol. The ordered film of soap molecules breaks up into individual molecules, and the bubbles disappear.
Warm water (80 degrees) dissolved the soap at the fastest rate = approximately 22% in 3 hours. Salt water dissolved the soap at the slowest rate = approximately 6% in 3 hours.
Hot water will make your bar soap dissolve more quickly and will require more effort to make lather.
Normally, a bar of soap is not big enough to clog up the sewage PVC pipe which is usually 2″ in diameter, a bar of soap could be very slippery, it won't clog up or plug up the toilet, will be dissolved in a day or two if it is accidentally flushed down the toilet. Don't worry about it.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
Soaps are unique compounds because soap molecules contain a small polar end (known as the polar head) and a long non-polar tail: Because of the two different parts of the molecule, a soap molecule is soluble in water and at the same time can dissolve fats.
Soaking up as much as possible with absorbent kitty litter or salt is an important first step. Pour either item on top of the spill and allow it to soak up the liquid for several minutes.
Descaling your kettle of limescale has never been easier thanks to Coca-Cola. Just boil a kettle full of Coke and leave to stand for 30 minutes. While other cleaning products may do a better job of restoring a shine to the showerhead, Coca-Cola can effectively unclog the head when other products fail.
Pour boiling hot water down the drain. This can dissolve mildew, slime, soap scum, and other similar clogs. Put half a cup of baking soda in the drain, then pour half a cup of vinegar down after it. Let this mixture sit for an hour, and then check the drain.
Destroy the scum: Soft Scrub with Bleach Cleanser on a wet towel will instantly cut through soap scum while killing mold and mildew. Soft Scrub cleans and disinfects tubs, countertops, shower fixtures, sinks, tiles, and toilets and leaves them shiny.
Add baking soda to the mix
Pour one cup of baking soda into the bowl and add two more cups of vinegar; the mix will start to fizz. Leave it like that for ten minutes without flushing.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Bleach is an effective way to deal with blocked toilet drains as it is a dilute solution of sodium hypochlorite and also contains a high chlorine concentration. Using bleach by itself or mixing it with boiling water are effective ways to unclog a toilet.
Professionals turn to sulfuric acid to break up extreme clogs. This pro-grade concentration quickly wipes out the toughest back-ups.