There is never a bad time to remove dead, damaged or diseased branches. But most trees benefit from pruning in mid to late winter. Pruning during dormancy encourages new growth as soon as the weather begins to warm. The lack of leaves after autumn allows you to easily identify branches and limbs requiring removal.
As a general rule, a light summer pruning can be performed on most deciduous trees and shrubs. Heavier pruning should be performed when the tree is dormant, preferably in late winter before active growth begins.
Municipalities and homeowners often remove the lower limbs for pedestrian and vehicular clearance or to let the sun shine in for grass to grow. Mature trees, especially evergreens, benefit when healthy lower branches are left intact. Removing large limbs can increase the risk of decay.
Tree pruning involves the removal of live branches, as well as dead, diseased, and damaged branches for the health of the tree, while tree trimming only involves the removal of branches that interfere in some way.
ALWAYS prune back to or just above a growing point (branch or bud) or to the soil line. NEVER leave a stem or branch stub. NEVER top a tree to “rejuvenate” growth.
Not using the proper techniques can damage the health of your tree and can even lead to disease or premature death. In general, don't cut too close to the trunk. These cuts are too big and can delay the sealing of the wound. Don't cut too far from the surface of the trunk, either.
An improper cut like a flush cut (cutting too close to the trunk) or a stub cut (cutting too far from the trunk) can cause irreversible damage to a tree. A flush cut removes the branch collar and leaves a large wound in the side of the tree that won't heal properly.
Helps Control Disease
Some trees, like oaks, should only be pruned during the dormant season because they are especially susceptible to oak wilt disease, which is known to spread extremely fast in the spring and summer.
As a general rule, prune spring-blooming trees immediately after they flower. Prune trees that bloom in the summer or fall in late winter or early spring before the end of their dormancy. Routine pruning of dead or dying branches can be done at any time.
There is never a bad time to remove dead, damaged or diseased branches. But most trees benefit from pruning in mid to late winter. Pruning during dormancy encourages new growth as soon as the weather begins to warm. The lack of leaves after autumn allows you to easily identify branches and limbs requiring removal.
Wait till after the leaves fall. Mild fall weather may have you thinking about pruning shrubs and trees. But it's better to wait till late winter, or, at least, after leaves have fallen.
The first cut is a shallow notch made on the underside of the branch, outside the branch collar. This cut will prevent a falling branch from tearing the stem tissue as it pulls away from the tree. 2. The second cut should be outside the first cut, all the way through the branch, leaving a short stub.
While pruning, avoid cutting too close to the node as it can get damaged. However, don't leave more than 1 cm above the nodes. It can compromise the shape of your plant. While pruning, you need to use good-quality pruning tools.
In pruning, there are three primary types of pruning cuts, thinning cuts, reduction cuts, and heading cuts, each giving different results in growth and appearance.
The basics of hard pruning
The hard pruning approach involves cutting the entire plant down to around 3 to 6 inches from the ground in very early spring before any foliage is emerging. This timing will minimize stress on the plant and direct energy into the growth of new stems.
Trees absorb and store carbon dioxide. If forests are cleared, or even disturbed, they release carbon dioxide and other greenhouse gases. Forest loss and damage is the cause of around 10% of global warming. There's simply no way we can fight the climate crisis if we don't stop deforestation.
Palm Trees
These trees are a huge challenge to dispose of. That's because palm tree trunks are some of the most difficult tree material to run through a wood chipper. The texture and density of this wood are what make it very difficult to chip.
Some have learned that pruning wounds should be sealed with a pruning compound to “protect” the plant from insects and pathogens. However, scien- tific research tells us that pruning compounds and sealants actually do more harm than good when applied to plants (with one exception which I will mention later).
For a tree to completely compartmentalize and seal off the exterior of a severed branch, it may take upwards of 15 to 20 years. However, within the tree, this containment process is fast-paced and extremely effective.
Can tree branches grow back? When pruned properly, removed tree branches will not grow back. Instead, the tree will grow what looks like a callous over the pruning cut, which helps protect the tree from decay and infection. Because trees heal all on their own, you don't have to use a pruning sealer!
The 1/3 rule involves cutting about 1/3 of wood during any pruning activity. This moderate pruning practice is a balanced approach to thinning out shrubs to stimulate new growth. The plant loses a good amount of stems, usually on the top section, allowing more light and air to enter the inside of the plant.