White vinegar and water, another common household cleaner, can also be used on mildew. For brick pavers that get a greenish or blackish hue from moss and lichen, damp shady environments, or water run-off, the BIA recommends bleach and water (mixed with a one-to-one ratio) or commercially available biocide treatments.
There are useful tools for cleaning paving stones, such as joint scrapers, sweepers, and pressure washers. In addition, pavers can be cleaned with a small pickaxe, broom, and garden hose.
Use a specialist cleaner
Try a specialist cleaner like Wet & Forget, at Walmart, which you spray onto the surface of the paving and leave. It can also be used on steps, fountains, patio umbrellas and other smaller outdoor areas. It's bleach-free and non-acidic but will remove mold, moss and grime without any scrubbing.
To clean paver slabs, you can use a detergent, such as Dawn, or a vinegar-water solution that is gentle enough to effectively clean without causing damage to your concrete pavers.
Can you power wash pavers? Power washing (also known as pressure washing) is also a very effective method by which you can remove dust deposits and various stains from your pavers. Just make sure that the water jet is not directed directly at the joints between the paving stones.
White vinegar is good for cleaning pavers, though it's also acidic enough to erode the stones' surface. Diluted vinegar can be used safely to clean paving stones, though it should be used sparingly and infrequently to protect your paving from damage.
Cleaning your pavers with bleach has a lot of benefits: Disinfecting the Surface: Bleach is an effective disinfectant and can kill any bacteria or mold on the surface. This will help to prevent any health hazards from occurring. Removing Tough Stains: Bleach is also effective in removing tough stains from the surface.
On the other hand, baking soda is useful because it is slightly abrasive, which is excellent for the rough surfaces of paving slabs. When it is mixed with water, it can dissolve dirt and grease, and like vinegar, you'll only need a brush or broom when cleaning.
You can use a pressure washer on your patio pavers if you want to clean stubborn stains or mildew from them. However, be very careful when doing this! Use a gentle spray and avoid letting the water run down the sides of your pavers, especially if they're set in the sand rather than mortar.
Apply the Simple Green solution. Allow the product to soak for a minute or so on heavy soils and greasy spills. Scrub, if necessary. Scrubbing with a soft bristle brush or non-abrasive scrubbing pad provides agitation that will help to loosen soils and will ensure a thoroughly clean, residue free surface.
Dry brushing with or without application of clean sharp sand. OR High pressure water jetting with or without detergent. OR Apply fungicides. Use ordinary bleach or calcium chloride followed by sodium hypochlorite dissolved in water (1kg in 5 litres) then scrub with stiff brush.
OxiClean is a powerful concrete cleaner that works well on various materials, including pavement and grout. This concentrated solution provides excellent cleaning without leaving residue.
A dish soap, like Dawn, is a safe place to start. The surfactants in dish soaps are designed to remove oil and grease, they're gentle enough to be used without issue on your pavers. In a bowl or bucket, mix the soap with water and pour it onto the stain and agitate. Rinse and repeat if needed.
Here are a few great solutions for cleaning brick pavers: White (not dark) vinegar diluted with water. Simple Green, a gentle and chemical-free soap that is unlikely to ruin your paver stones. Dishwashing soap and water.
Try Concrete Stain
The simplest path to reviving tired pavers is to apply an acrylic-based semitransparent concrete stain, such as Behr Premium Semi-transparent Concrete Stain ($27/gal.; Home Depot) or Valspar Semi-transparent Concrete Stain ($28/gal.; Lowe's).
'A homemade cleaning solution for your patio can be made by mixing equal parts water and white vinegar,' says Zak. 'This natural cleaner is effective in removing dirt, mildew, and algae. For stubborn stains, you can add a few drops of liquid dish soap to the mixture.
3) USE A CLEANER FIRST
I used a bleach-free pressure washer concentrate and sprayed it over each section to help loosen the grime before going at it with a higher pressure nozzle. It didn't take long to apply and helps get those stubborn mildew stains out.