However, if the clog is especially tough, your plunger may not be enough. So, what else can you do to clear a badly clogged toilet? The first thing you should do is stop flushing. If your toilet doesn't drain, persistent flushing will only fill the bowl with more water, making the problem worse.
Stop Flushing!
The clog will prevent the water from going down the drain, meaning it will overflow the toilet and get all over the floor. This can create a much bigger (and must smellier) mess. You should never flush a clogged toilet more than once.
Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs. Be patient.
If water is rising in the bowl immediately after you've already flushed, that means a clog is blocking the water from moving through the toilet drain. If you flush again, there will be even more water that's unable to make it past the clog, and you'll end up with even more flooding from the toilet bowl.
Using a plunger, place the cup end over the drain at the bottom of the toilet, submerged in water. Move the plunger up and down rapidly and steadily several times. If the toilet drains, great, but if not, look for a foreign object; wearing gloves, you may be able to reach in and grab it.
You may just be using it incorrectly. Do this: Next time you have a clog, use your plunger like this: Ensure the flange lip is unfolded. Get a good seal on the toilet drain (that is, make sure you're covering the entire drain or you won't have enough pressure to loosen the clog.)
Ideally, no more than five or 10 minutes. One plumber told us that if plunging goes on any longer, it's time to try a toilet snake or call an expert.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
Using a plunger is one of the most effective methods used for unblocking a toilet as it can unclog a wide variety of waste pipes.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
Attempting to force a clog through a toilet with a plunger can often make the problem worse. Instead, create a seal and slowly push down on the plunger before pulling it back sharply. The suction can help pull the clog back up toward the bowl, breaking the blockage and allowing gravity to take over.
Will a toilet eventually unclog itself? It sure would be nice, but it's fairly rare for a toilet's clog to clear up after a few hours. It can happen, but only in select circumstances.
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water. For tough problems, allow 30 minutes before flushing.
Hot Water and Dish Soap
Wait for 10-15 minutes while the dish soap and hot water soften the clog. Once you do so, the toilet will unclog and flush freely. Alternatively, you could use hot water and shampoo from the sink if you wish to clear your toilet without leaving your bathroom.
Many people think that a forceful push into the plunger is what frees up the clog, but this can often worsen the problem. In fact, pushing the plunger in with enough force can even break the seal of the toilet gasket (the seal between the toilet and the floor where the plumbing exits).
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Using a snake is also more invasive and time-consuming than using a chemical cleaner is, and can often become a dirty job. When it comes to getting at and removing major clogs or clogs that are deep down in your pipes, however, a plumber's snake is your best bet.
Drano is not only ineffective, but it's also extremely damaging to your plumbing system. The heat created by the chemical reaction is more than your drains are designed to take. Corroded, aging plumbing can easily breakdown. Pipes can split and the glue holding them together can disintegrate.
Why Plumbers Dislike Drano & Other Liquid Plumbers. One of the main reasons plumbers dislike liquid drain cleaners is that they can actually cause more harm than good. These products contain harsh chemicals that can corrode your pipes and cause damage over time.
A snake is safer to use on tough clogs than a plunger, which can apply too much pressure on the wax ring at the base of the toilet, causing it to break—and it's also gentler than a liquid dissolving solution, which can corrode your pipes.
Can you leave baking soda in the drain overnight? It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain.