After a thorough cleaning, you can run a very thin layer of Vaseline or petroleum jelly to the surface of the gasket, especially where it touches the fridge. This can help fill in any tiny gaps, improving the seal.
To get that seal snug again, find a strong magnet. Magnetic strips embedded in the door's gaskets are responsible for making the door shut tight, so run that magnet 50 times along each side of the gaskets, all in the same direction. That will remagnetize the strips and restore the seal.
Check the condition of the gasket (door seal) around the door inside, if it is dirty, or has any food particles on it or frost that will need cleaning. Check the storage bins, drawers and shelves are in place and pushed back correctly.
Replacing your fridge seal is not just a maintenance task; it's a smart, cost-effective investment in the efficiency, longevity, and reliability of your refrigerator. Don't let a faulty seal compromise your appliance's performance.
Once your fridge door gasket is wiped clean, there's a very handy trick you can use to improve both the performance and the functional life of your gasket seal. All you need is a tiny amount of petroleum jelly.
Common reasons the door won't stay closed
The refrigerator door hinge is loose and therefore causing the door to not close or shut properly. Check whether the door seal is blocked by debris that prevents the door from closing. To clean the door seal, use a soft cloth with warm water.
If dirt or debris is preventing your fridge door from sealing properly, all you have to do is give it a thorough (but gentle) cleaning. Use warm soapy water and a soft dishcloth to carefully wipe down the gasket and the surface it seals against. Take care to gently open the folds of the gasket to remove any crumbs.
If refrigerator doors don't close on their own, it may be because the refrigerator is tilted forward. Adjusting the front of the refrigerator slightly higher than the back will allow the doors to close more easily and with little force. Adjusting the refrigerator's tilt is done by adjusting the leveling screws.
After a thorough cleaning, you can run a very thin layer of Vaseline or petroleum jelly to the surface of the gasket, especially where it touches the fridge. This can help fill in any tiny gaps, improving the seal.
After years of using your fridge or freezer, you might notice a deterioration in the magnetism of the door seal. To remagnetize the seal or rubber gasket, you will simply employ a magnet to reestablish the seal's magnetic field.
With proper maintenance, fridge door seals can last 5 to 8 years, but this can vary based on usage and environmental conditions.
Seal Kits: Prices range from $90 to $120 for both fridge and freezer seal. Installation: the price for us to Supply and Install a Single Fridge or Freezer Door seal starts at $160 and for both door seals $230+ depending on your location, cabinet, and seal type.
Protect your new rubber car seals
To elongate the life of the seal, you can take steps to protect the rubber. WD-40® High Performance Silicone Lubricant is ideal for use on rubber materials.
Repair the Door Seal
To repair a torn door seal, waxed paper and silicone sealant can be used. Clean the door seal, removing grease, grime, and mold. Apply an even layer of silicone sealant to the damaged area so that it gets inside any gaps in the seal. Carefully cover the silicone with a 2-inch strip of waxed paper.
Replacing the seal is easily done in three simple steps: Remove the old gasket by either loosening the screws slightly or gently pulling it out of its place. Fit the new seal by either sliding in and tightening screws or by pushing into place. Check the seal is fitted well and adjust if needed.
Fridge Seal Replacement
The average price to replace the seal depends on the size and model, averaging $60 to $100.
One of the most common reasons for fridge seal failure is simply the age of the refrigerator. Over time, rubber and plastic components like seals can lose their elasticity and strength.