Clarifier works to clear mild cloudy pool water. Add it every other day as your filter runs until your water clears. If you have extremely cloudy water, you need to use a pool flocculant.
If your pool is just mildly cloudy and you are not in a rush to clean it out, a clarifier may be your best bet. A clarifier requires less work and less water but can take to two to three days to achieve the results you are looking for.
What happens when you add too much clarifier is that all the little particles clump together too much an end up as a colloidal suspension. When that happens, the whole thing turns cloudy.
To maintain a clear sparkling pool add 4 fluid ounces of Water Clarifier per 10,000 gallons of water weekly. If the pool is cloudy due to dust or to high hardness of the water, add 32 fluid ounces of Water Clarifier per 10,000 gallons of pool water.
Some of the best natural homemade pool clarifiers include baking soda solution, bleach, white vinegar, lemon juice, rubbing alcohol and borax. Compared to commercial chemical clarifiers natural ones have enzymes that break down the dirt in the water making it easy and cheap to filter them out.
It's usually just a temporary reaction as the sanitizer works its magic, and doesn't always indicate a problem. But if the cloudy water persists long after you've shocked the pool, you're likely having an issue with water balance, circulation, or filtration.
Cloudy or milky swimming pool water is caused by seven main issues: improper levels of chlorine, imbalanced pH and alkalinity, very high calcium hardness (CH) levels, faulty or clogged filter, early stages of algae, ammonia, and debris.
It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
For the most part, yes. It can be unattractive and it should be addressed, but it is mostly safe to swim in cloudy water. The only exception would be if the pool is cloudy because there are too many chemicals in it. This pool water would be unsafe to swim in and should be avoided.
It is recommended to wait at least 20 minutes to an hour after adding water balancing chemicals.
Pool flocculant can clear up your cloudy pool water in 1 or 2 days. Though it works faster than pool clarifiers, it will need 8 to 16 hours to clump together the particles before you can vacuum. Add flocculant to your pool with your filter on “recirculate.” Then let the flocculant sit overnight with your pool pump off.
Skim the top of the pool for debris that may have settled on the pool surface. Add one pound of diluted granular shock to the water for every 7,000 gallons of pool water. Run the filter for 24 hours and retest the water. The slimy looking film can be an early onset of algae.
When should Pool Clarifiers be Used? Pool Clarifiers are not meant to be used all season long, but are quite helpful at pool opening, after an algae bloom, or battles with cloudy pool water. Follow label directions, but most pools can be retreated after 5-7 days, with a lower dosage than initially used.
Adding a recommended dose of shock to your pool can clear it right up. Poor circulation or filtration can contribute to cloudy water. Make sure your pump and filter are working properly.
Baking Soda
Most remedies call for adding additional chlorine into the water. If your water's pH balance is between 7.2 and 7.5, however, you can add baking soda to the water to help clear it up. This serves as a replacement for chlorine because baking soda is a natural cleaning agent.
A pool turns green when there is algae in the water. There are several reasons why algae could grow, but it is most commonly caused by prolonged exposure to the sun, rain and temperature spikes. These factors affect the chemical balance of the pool and result in the pool turning cloudy and/or green.
Here is why: Sunlight is white, which is made up of all the colours of the spectrum. The molecules in pool water absorb light from the red end of the spectrum when sunlight falls on the water. By removing the red, the light which ends up being reflected has a slightly blue hue which can vary in richness by water depth.
Most swimming pool owners choose blue tiles for their pools to match the color that reflects the sky's blue color. Blue is also a highly desirable water color. In fact, many vacationers search for countries surrounded by blue ocean water and white sand beaches.
GETTING RID OF ALGAE
Please note that our liquid algaecides are compatible with alkalizing and flocculating agents used in other pool maintenance products. Our Liquid Algaecides are patented formulas that not only work as preventatives but as a pool clarifiers that inhibit algae growth of all types.