What happens if your swimming pool water level is too high? If your pool level is too high, your skimmer won't work as efficiently.
Your pool skimmer will help filter out some debris and insects that enter your pool, but only if the water level isn't above the skimmer opening. If the skimmer is completely covered by water, then it won't work properly. ... Maintaining your pool before a storm will help alleviate any problems that a storm might cause.
If the water level is too high the debris floating next to the opening may pass by without being pulled into the skimmer. However if the water level is too low it may cause the skimmer to suck air into the system. If this happens you may run the risk of burning up your pool pumps motor.
It is recommended you have your water level between one-third and one-half up the swimming pool skimmer box opening. If the level is higher than that, it may slow or even stop debris from being pulled into the skimmer box through the plate or valve.
After an extreme overflow, you will need to remove water from both the outside and inside of the pool. You may also need to adjust your pool chemicals, since the extra water may dilute the water and reduce the effective chemistry.
But large quantities of precipitation combined with an overflowing pool and poor drainage can cause problems such as flooding, structural damage to the surrounding buildings as well as out of balance swimming pool water chemistry.
The pool will only overflow by the amount of rain in excess of the amount of rain needed to fill the pool to the top. So if your pool is the normal 3” below the top, the rain would need to exceed 3” before any additional rain would be available to overflow onto the deck.
Low Water. Allowing the pool water level to drop too low, meaning below the skimmer, is a big no-no. If this happens, the pump will draw air instead, resulting in loss of prime and running dry. Catch this in time, stop the dry run, and you might have to say good-bye only to your shaft seal – but be sure to replace it.
Ideal Water Height
Most pool professionals agree that the water level in both in-ground and above-ground pools should be at the midpoint of the pool skimmer. The skimmer is responsible for providing a pathway for water to flow to the filter where it is cleaned.
You don't need to drain your pool, as there is no risk to your pool by it being full. The only thing you lose with a pool filled to the rim is your skimmer's surface cleaning action. Overall, it still draws water and the equipment is just fine.
How Often Should I Shock My Pool? Shocking your pool regularly will help to keep the water clean and free of contaminants. You should aim to shock your pool about once a week, with the additional shock after heavy use. Some tell-tale signs that your pool needs to be shocked are cloudy, foamy, green, or odourous water.
Above ground pool skimmers are typically located in a unit that hangs on the side of the pool, with the basket slightly submerged in the water. It works much like an inground pool skimmer in that it pulls the top layers of water into the basket to filter out debris.
The best above-ground pool skimmers
The above ground pool skimmer hangs on the side of the pool frame and slowly draws in water. It catches debris like leaves and grass before it can sink to the bottom of your pool, leaving clean, blue water for you to enjoy.
If the water in your swimming pool is too low, the skimmer can bottom out and suck air into your filter system. And when that happens, you're at risk for burning out the motor on your pool pump. This could be a costly problem, which is why you should definitely keep an eye on the water level of your swimming pool.
Your skimmer sets the pool waterline basically. The pool water is normally one half the way up the face. If you use the overflow in the skimmer the pipe should go to a drain system or drain area. It is important that you do have an overflow release for you pool.
Slot Drain Systems offer a pool overflow drainage system that is installed around the rim of the pool. This drainage system helps manage and prevent water overflows in and around pools.
The skimmer can be found under the top edge of the swimming pool. This is the main distinction between the skimmer pool and the overflow poo,l where the surface of the water is even with the edge of the pool deck. With smaller skimmer pools, water is drawn from top to bottom in order to be cleaned.
Above Ground Pools
One of the most common concerns some people have is that the walls may begin to have too much pressure and weight from the excess water. There could be a few reasons when it may become a reasonable issue, but in most cases you should be fine.
Inground pool skimmers are a rectangular shape. Depending on the size of your pool will dictate how many skimmers the pool will have. They are located inside the pool, toward the top of the wall. Normal operation requires the skimmer to be filled to the middle of the skimmer with pool water.
No matter what kind of pool you have, it's very important to have a properly functioning pool skimmer. Without it, you could wind up with a less beautiful pool, improper cleaning and an overworked pump.
A skimmer should be placed in the path of circulating water. There aren't any hard rules on location, especially with the popularity of free form pools.