A manual drain snake, also known as a plumber's snake or a drain auger, is a small boring tool that rotates slowly as it's physically pushed through a stubborn clog. The terminal end of the device is a corkscrew-shaped hook that is fed into a clogged drain or toilet.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
You may just be using it incorrectly. Do this: Next time you have a clog, use your plunger like this: Ensure the flange lip is unfolded. Get a good seal on the toilet drain (that is, make sure you're covering the entire drain or you won't have enough pressure to loosen the clog.)
Attempting to force a clog through a toilet with a plunger can often make the problem worse. Instead, create a seal and slowly push down on the plunger before pulling it back sharply. The suction can help pull the clog back up toward the bowl, breaking the blockage and allowing gravity to take over.
Locate a measuring cup and pour half a cup of dish soap into your toilet. Give your soap about five to 10 minutes or enough time to travel down your drain to reach your clog. Then, add hot (not boiling) water and let it sit. Dish soap serves as a lubricant, greasing your clog and dislodging debris.
Soap and Hot Water - Remove some of the water in the toilet with a cup or bowl to make room for adding about a gallon of water. Put a soap dish, shampoo, or slivers of bar soap in the bowl. Then heat a gallon of water to the temperature of hot tea, pour into the bowl, and wait about 20 minutes.
Using a plunger is one of the most effective methods used for unblocking a toilet as it can unclog a wide variety of waste pipes.
If a plunger or plumbing snake doesn't work, water and soap might do the trick. Boil a gallon of water and allow it to cool for about 10 minutes. As you wait, pour a cup of liquid dish soap into the toilet bowl. You can then pour the water slowly into the bowl — leave it for about 20 minutes before flushing.
If the clog still seems to be intact, start over at step 1 and repeat the process a couple of times. For extra-stubborn clogs, you can let the fizz mixture sit overnight or combine this method with plunging.
For extra-stubborn clogs, you can let the fizz mixture sit overnight or combine this method with plunging. If your toilet remains clogged or continues to get clogged, this may be an indication of plumbing problems such as mineral buildup or pressure issues.
Pour one cup of baking soda into the clogged toilet, and then chase it with the hot water/vinegar mixture. Leave the volcano mix to do its job, checking in about 30 minutes. In most cases the clog will have come apart, and a simple flush with send it all down the drain. Plus your toilet bowl will be cleaner!
It could be a non-flushable item, too much toilet paper, or simply excess waste. If your toilet constantly clogs, there's a reasonable chance that the S-trap has a lot of matter stuck inside. Unclogging the S-trap may be the answer to why your toilet clogs easily. Plunging should move most clogs along.