Essentially, any time your pool cover has more than 2 inches of water on top of it, be sure to drain the excess water off as soon as you can before it builds up. Remove as many leaves as possible after they all fall and before the water on top of your cover freezes.
Before you can remove the cover, you have to remove the water that's on top of the cover. While you can try siphoning the water off with a garden hose or scooping it with a bucket, a much more effective method is to use a pool cover pump.
The water level should not be lower than 18” from the top of the pool. If your water level goes down further than 18”, the cover could stretch out too much and either rip or cause anchors to pull out of your deck.
The cover is designed to touch the surface of the water. So your pool should always be filled when covered, and the water level should never go below 18 inches from the top of the pool. Check the water level of the pool and fill it up if it goes below 18 inches.
Is It Safe To Run The pool Pump With The Pool Cover On? It is safe to run the pool pump and filter with a swimming pool cover on. The pool cover doesn't in any way stop or hinder the pool pump from circulating the water or carrying out its function.
Safety covers should be drum-tight, with only a slight deflection in the middle. When covers are too loose, leaves can blow under easily, and a high water level in springtime quickly traps leaves and turns your cover into a giant tea bag.
Although it's not recommended for a major storm, you can use a pool cover for lighter sprinklings, or moderate rain that doesn't involve any severe wind to protect your water. Remember, the rain is acidic and is out to get your chlorine.
Keep The Middle Section Of Your Pool Cover Higher Than The Sides. By ensuring that the center of your pool cover is higher than the sides, you'll prevent water from collecting at the sides.
After it rains, you should remove standing water as soon as possible. To do this, you'll want to use a siphon or a water pump. An automatic pool cover pump is one of the most useful pool supplies in New Haven County, CT because it can remove standing water from your cover without you needing to do the work.
Above ground pools don't typically use weights. Because these pools are higher off the ground, the cover is usually tied down. This can be done by getting a cover that ties to the pool frame itself, or by putting stakes and tie downs in the yard around the pool to hold the cover in place.
Pool covers can be used on indoor and outdoor pools, as well as in-ground and above-ground pools, of almost any size or shape. Using a pool cover can prevent up to 95 percent of pool water evaporation.
A small bit (1/4″-1/2″) of rain water is OK, but more than that could stress the cover, and 6-12″ of water will push pool water over the edges, lowering pool water (see above). Pump regularly with a pool cover pump like our manual or automatic 350 GPH pump or the non-electric Cover Saver siphon pump (shown).
Safety cover sagging is okay, well in most cases. It is not the safety-cover that supports the snow and ice. It is the water underneath your cover that helps it and keeps it from sagging too much. Whoever sold you the cover should have warned you or directed you to read the directions.
We strongly recommend using an air pillow under your winter cover. The first reason to install a winter cover air pillow is to protect your pool from expanding ice. When you don't use an air pillow, the cover sits right on top of the water and the ice will want to expand outwards.
In dry and/or windy conditions, the evaporation rate of the pool increases. Therefore, it is generally beneficial to have a transparent or bubble cover on during daylight hours. In warm, humid conditions the evaporation rate decreases. In this case, it may be more beneficial to leave the cover off during the daytime.
If you don't cover your above-ground pool, it's going to get dirt, leaves, and other debris in it. Even if you don't have any trees nearby, the wind will still blow debris into the water. Not to mention rainwater!
Tie strong string or thin rope to both ends of the pillow; it should have grommets on the edges for this purpose. Place the pillow in the center of the pool. Secure the other ends of the strings to the edge of the pool to keep the pillow in place.
You may have heard pool owners recommend alternatives to pool air pillows, such as tire tubes, yoga balls, or regular innertubes.
There is little doubt that pool covers do reduce evaporation. It's been scientifically proven many times. Some councils and water authorities now believe in them so much that they now give rebates just for buying a pool cover.
Air bubbles in the pool cover act as an insulator in a similar way that your thermos would keep water warm. A pool cover will, therefore, keep your pool water warmer for longer.
You should cover your pool every night for several reasons. First off, a pool cover saves energy and conserves water by decreasing the amount of make-up water. Also, it reduces the consumption of chemicals, and finally, it saves a lot of cleaning time since it keeps the debris out of the pool.
So while a solar cover won't actually 'turn your pool green', it will warm your water by up to 8 degrees, so if the other conditions are right, adding a solar cover can easily accelerate algae growth, very rapidly. You need to get the water balance in your pool right before putting the cover back on.
We recommend it, yes. A pool cover does much more than just cover your pool in the winter. It can keep heat in your pool, keep leaves out of the pool, and save your chemicals and water from evaporating.
The size of your pool, the efficiency of your pump and filter, and how dirty your pool is are just some of the factors you need to consider. Nevertheless, most pool cleaning professionals would advise against running a pool pump for more than 8 hours a day.