Lysol can be hard to find online and in-stores, but Pine-Sol seems to still be available at most retailers. Compared to Lysol, Pine-Sol has a longer contact time (Lysol's ranges from 2 minutes to 5 minutes) but will still effectively help you to limit your contact with the virus.
Pine-Sol vs Lysol
Lysol works just like Pine-Sol and will get rid of bacteria, fungi, mold, viruses, etc. after getting into contact with the surface for at least ten minutes. However, it may not be as effective if there are organic materials.
The Environmental Protection Agency recommends phenolic solutions (such as concentrated Lysol® or concentrated Pinesol®), mixed at two to four times the manufacturer's recommended concentration, as best for surfaces that could be damaged by bleach.
The best disinfectants for viruses are alcohol, bleach, hydrogen peroxide, and quaternary ammonium compounds. These active ingredients are the most common on the EPA's list of registered disinfectants against the coronavirus.
Pine-Sol® is not recommended for use on marble, aluminum, or unsealed, waxed, oiled or visibly worn wood.
A: Yes. Original Pine-Sol® Multi-Surface Cleaner is registered with the EPA as a disinfectant when used as directed full strength. When used according to the instructions on the product, it kills 99.9% of germs and household bacteria on hard, nonporous surfaces.
Some of the problems that can be caused by inhaling Pine SOL
However, the most common health problems are listed below: Irritation of the mucous membrane. Nausea and headache. Loss of consciousness.
In addition to a vast array of detergents and cleaning/disinfecting equipment, common chemicals used for disinfection include: alcohol, chlorine and chlorine compounds, formaldehyde, glutaraldehyde, hydrogen peroxide, iodophors, ortho-phthalaldehyde, peracetic acid, phenolics, and quaternary ammonium compounds [17].
Currently, there are five main EPA-registered chemicals that hospitals use for disinfectants: Quaternary Ammonium, Hypochlorite, Accelerated Hydrogen Peroxide, Phenolics, and Peracetic Acid.
The antibacterial wipe with the greatest number of bacteria killed (on average) was Clorox, with 20 bacteria killed. Green Works and Supreme Clean tied together, for second, at 14 bacteria killed. In conclusion, antibacterial wipes with the greater amount of Clorox are more useful in killing bacteria.
A little-known fact about noroviruses is that many household cleaners and wipes don't kill them. Clorox and Lysol Disinfecting wipes claim to kill 99.9 percent of viruses and bacteria, but that doesn't include noroviruses.
You should use a chlorine bleach solution with a concentration of 1,000 to 5,000 ppm (5 to 25 tablespoons of household bleach [5% to 8%] per gallon of water) or other disinfectant registered as effective against norovirus by the Environmental Protection Agency (EPA).
Or for everyday mess control, keep the Pine-Sol® mixture in a spray bottle for quick cleaning spritzes. Scrub crevices in counters with grout with an old toothbrush. Scrub stubborn messes or stains with full strength Pine-Sol®, using plastic scrubbing pad or cloth. Finish by rinsing with water.
What is this? Pine-Sol is more acidic than Fabuloso, which gives it an advantage in breaking down stubborn stains and complex messes caused by grease. Pine-Sol Original is the only liquid cleaning solution that disinfects.
Pine-Sol gives the same advice. PineSol.com states, “We do not recommend mixing any Pine-Sol® product with other cleaning products or chemicals. Mixing cleaners can result in the release of hazardous gases.”
Hypochlorites. Hypochlorite-based disinfectants are very effective against many types of germs and bacteria. The most common hypochlorite disinfectant is sodium hypochlorite, which is more commonly known as household bleach.
Clean products are designed to clean big, tough messes, whereas the primary purpose of Lysol products is to disinfect surfaces. Mr. Clean offers a variety of products but only has one antibacterial cleaner. Lysol, on the other hand, focuses on disinfecting sprays and wipes as well as multi-purpose cleaners.
Disinfection Versus Sterilization
There are three levels of disinfection: high, intermediate, and low. The high-level disinfection (HLD) process kills all vegetative microorganisms, mycobacteria, lipid and nonlipid viruses, fungal spores, and some bacterial spores.
Hydrogen Peroxide
H2O2 disinfectants tend to kill a broad spectrum of bacteria and viruses quickly, are mildly acidic, and are effective cleaners. Some RTU products such as Nyco HPX Hydrogen Peroxide Disinfectant Cleaner will kill the SARS-CoV-2 in as little as one minute.
Cleaning – removes dirt, dust and other soils from surfaces. Sanitizing – removes bacteria from surfaces. Disinfecting – kills harmful bacteria and viruses from surfaces. Sterilizing – kills all microorganisms from surfaces.
A “Hospital Grade” Disinfectant only requires 2 organisms to be tested: Pseudomonas aeruginosa and Staphylococcus aureus. A one step disinfectant cleaner is an EPA registered disinfectant that has been tested in 5% blood serum.
Swallowing pine oil can have severe effects on many parts of the body. In most cases, the biggest problem is that pine oil is swallowed (aspirated) into the lungs instead of the stomach, causing breathing problems.
Lysol contains denatured ethanol, which is poisonous to humans. High concentrations of Lysol can also cause lung irritation.
– New independent lab testing on 20 top household cleaning products reveals that top-selling cleaning products and detergents, including Tide Free & Gentle, Pine-Sol and Simple Green All-Purpose Cleaner, contain toxic chemicals not revealed to the consumer.