Along with the smell from the clog, you may smell bacteria as it grows. The sitting water gives bacteria ample time to set up shop. Not only is this gross, but it also makes dealing with the clog in the morning less sanitary too.
Is it okay to leave a clogged toilet overnight? In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
Wait about 10-15 minutes before trying to unclog the toilet, as some water might drain on its own. Squeeze a lot of liquid dish soap, about one cup, or pieces of bar soap into the toilet bowl.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
Boil a gallon of water and allow it to cool for about 10 minutes. As you wait, pour a cup of liquid dish soap into the toilet bowl. You can then pour the water slowly into the bowl — leave it for about 20 minutes before flushing. The combination of warm water and soap can loosen the clog, making it easier to flush.
It isn't enough to notice with your eyes, but if you leave the problem for several hours, and the water has nowhere to go, the toilet will overflow.
When you have a clogged toilet, but you don't need to use it right away, you might wonder if you can just wait and let the clog sort itself out. Will a toilet eventually unclog itself? It sure would be nice, but it's fairly rare for a toilet's clog to clear up after a few hours.
You may just be using it incorrectly. Do this: Next time you have a clog, use your plunger like this: Ensure the flange lip is unfolded. Get a good seal on the toilet drain (that is, make sure you're covering the entire drain or you won't have enough pressure to loosen the clog.)
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
Attempting to force a clog through a toilet with a plunger can often make the problem worse. Instead, create a seal and slowly push down on the plunger before pulling it back sharply. The suction can help pull the clog back up toward the bowl, breaking the blockage and allowing gravity to take over.
Check water level in toilet bowl
Listen for a gurgling sound from the drain (a good sign) and check the water level in the toilet bowl. If nearly all the water drained from the bowl, then you've probably cleared the clog.
How to Tell if Your Toilet is Clogged. Signs that your toilet (or sewer line) is blocked include: The water does not flush properly, stays in the bowl for long periods or ends up overflowing over the top of the bowl. When the toilet is flushed, water starts to gurgle up in your shower or bathtub drain.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Can you leave baking soda in the drain overnight? It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain.
You can also pour vinegar down the drain on its own.
Pour about 1 cup of vinegar down your drain and let it sit for 30-40 minutes.
You may be surprised to learn that pouring soda down the drain does work for some clogs. To be specific, you need a dark-colored cola (such as Coca-Cola or Pepsi). This type of carbonated beverage usually contains a good amount of phosphoric acid, which given enough time, can eat away at some types of clogs.
Check water level in toilet bowl
After plunging for thirty seconds, quickly break the seal and remove the plunger. Listen for a gurgling sound from the drain (a good sign) and check the water level in the toilet bowl. If nearly all the water drained from the bowl, then you've probably cleared the clog.
Give a few good up and down strokes with the plunger and flush the toilet. If the water clears from the toilet, then you've successfully unclogged it. If the toilet starts overflowing again, just close the flapper to stop water from entering the bowl. Repeat the plunge and flush sequence until your clog is gone.
Here's what to do: Pour 1 cup of baking soda and 1 cup of vinegar down the toilet drain. When the vinegar and baking soda combine, the natural chemical reaction will bubble up and loosen the clog. After about 30 minutes, follow up with some hot water and see if it drains. If it does, you're good to go.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
While it's true that sometimes all a clog needs to get moving is an extra flush, a person who flushes a clogged toilet runs the risk of the toilet overflowing. Wait until the clog is loose to attempt flushing.