A pool filter should be run for a minimum of 6 hours after shocking a swimming pool. This is to allow the filter to clean the water and give the shock enough time to fully mix with the pool water. Running the filter after shocking for 24 hours to 7 days is necessary if the pool has a large amount of algae.
Run the filtration system
While shocking your pool will help kill any germs any algae, it won't actually get rid of them; for that, you need your filter. So be sure to run your pool filter for at least 24 hours.
Now it's time to wait a while.
Give the shock a good 12 to 24 hours to work it's magic. If the algae hasn't cleared up after 24-48 hours, clean and brush the pool and add another shock treatment.
In the industry it is recognized to have the pool run for 3 hours at a bare minimum up to 24 hours. 24 hours really is overkill but it'll ensure the water is completely mixed with the chemicals.
Answer: After shocking the pool, it will need filtration and circulation. Run the pump as much as possible. Keep the filter clean (daily) until the water runs clear. Be sure to brush the pool often during this process as above-ground pools do not have drains at the bottom.
Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up. Your pool is more vulnerable during the day, plants don't grow at night the way they do during the day–that's true of ALL plants including Algae.
Pools can immediately turn green after shocking when they have metals like copper or iron in the water. These metals oxidize when exposed to high levels of chlorine which makes the pool water turn green. Metals in the water are caused by some algaecides and using well water.
Chlorine is a sanitizer, and (unless you use Baquacil products) is necessary for maintaining a clear and healthy pool. Shock is chlorine, in a high dose, meant to shock your pool and raise the chlorine level quickly.
What happens if too much shock is added? You cannot overshock a swimming pool or add too much. Adding too much shock or overshocking your pool will kill off algae. The negative of adding too much shock is it will upset the chemical balance of your pool.
The best time of day to shock your pool is in the evening. This is because the sun's rays can affect the effectiveness of the chlorine by dissolving it too quickly, before it has a chance to rid the pool of contaminants and clean the water.
Symptoms usually develop in 3 to 5 days in women who are menstruating and using tampons. If you experience the above symptoms after using tampons or after a surgery or skin injury, contact your health care provider immediately.
Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time. Residential pool water only needs to be turned over once daily to have proper filtration.
Liquid chlorine and granular shock have the same active chemical that sanitizes your pool, what changes is the strength and the way you use it. Liquid chlorine is less costly, unstabilized and comes in liquid form. Granular shock is stabilized and comes in a solid form that dissolves in your pool.
So if you buy liquid shock, be aware that it only lasts one to two months at the most before it starts to lose effectiveness. While many swimming pool chemicals stay good for years if stored correctly, some pool-maintenance supplies expire more quickly.
This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.
The best time of day to shock pool is when the sun is down. So, experts recommend shocking your pool in the evening or at night, to make sure it does its job. Shocking during the day can be ineffective as UV rays from direct sunlight significantly reduce free chlorine levels.
It's pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn't be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.
You should run your pump/filter as long as it takes to keep the pool clean. Some pools have great circulation combined with low use, therefore run times can be quite short. Other pools have lousy circ systems and huge bather loads and even 24/7 filtration has trouble keeping up.
Chemicals that you add to your pool while the water is circulating don't need to be recirculated; they will stay mixed even if you don't pump the water continually. Although it's generally recommended that all the pool water undergo filtration every 24 hours, the pump does not need to run all the time.
Run the pump for 8 hours, every 24 hours. You can also pause in between; there is no need to run it continuously. Ideally, after you shock the pool, be sure to run the pump at night and during non-peak hours, to save on your energy bills.
Depending on the size of your pool, we still recommend you run your pump run at least 4-6 hours a day during the fall and winter months. The daily cycle can be divided into multiple cycles, but each cycle should be no shorter than 4 hours, for all the water to pass through the filter at least once.
After you shock the pool — As soon as your chlorine levels reach 5 ppm or lower, it's officially safe to swim. Depending on the type of shock used, as well as the amount used, it can take anywhere from 24 hours or even up to a couple of days.
Shock Your Pool with Chlorine to Kill Algae
This is the main event in clearing a green pool—killing the algae. Pool shock contains a high level of chlorine that will kill the algae and sanitize the pool. For the best results, use a shock that contains at least 70% available chlorine, and shock the pool twice.
One of the most significant consumers of energy in homes with swimming pools are pool pumps, which keep pools clean by circulating water through filters. Pool pumps can consume 3,000 to over 5,000 kWh per year.