Unplug the machine and wait 10 seconds. Plug the machine back in and press the ON button. You should see a blue light appear, letting you know that the machine has been reset.
Turn The Ice Maker Off and On Again
This is a simple matter of resetting the power to your ice maker. By flipping the switch off and back on, you may be able to reset the functionality so that your ice maker begins to dispense ice again.
Several problems can interfere with making ice properly or dispensing ice. The ice maker or dispenser could be jammed or broken, a dirty water filter or kinked water line could be blocking water flow or the water inlet valve could be clogged or faulty.
If you don't hear a chime and there is no movement from the ice maker, unplug the fridge or turn it off at the circuit breaker for 2 minutes. Then, power it back up and try again.
Check the fill cup and the tube at the back of the ice maker. If they are covered in ice, look for a blockage. If you see an obstruction, check out our guide on how to clean your refrigerator water line for detailed steps. If that doesn't work, consider replacing the water fill tubes.
If your ice maker isn't producing ice at all or is producing crescents or cubes that are smaller than usual, it's typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line.
Now that you have successfully reset your ice maker, it is time to put the ice bucket and covering back into place and wait. Be patient because it will take another 3-4 hours before your ice maker is full of ice again.
Reset your refrigerator: First, unplug it (or turn off the power at the circuit breaker), and then wait about five minutes for the electrical charge to clear out of it. Then, power it back on again.
The ice maker or dispenser could be jammed or broken, a dirty water filter or kinked water line could be blocking water flow or the water inlet valve could be clogged or faulty.
Once the cubes are pushed out, the arm falls again. When the arm reaches its lowest point, it flips a circuit switch, activating the water valve to begin another cycle. If the arm cannot reach its lowest position, it will not activate the cycle, which will keep your ice collection bin from overflowing.
There are several reasons your ice maker may suddenly stop working, including a blocked water dispenser, issues with your water supply line or a clogged water filter.
Your freezer temperature could be too high, the water inlet valve may not be functioning correctly, your home water pressure may be low, the refrigerator's water filter may be clogged, or the ice maker may need to be replaced.
If the Ice maker is making ice, but not dumping it into the ice bin try resetting the Ice Maker. To reset the ice maker, unplug the refrigerator for 1 minute. After resetting, wait a couple of hours and check for ice production; ice is in the bin.
This will be located at the bottom of the ice maker unit in most models, but in some, it is at the bottom of the ice tray itself. Press the button down until you hear a beep sound. It will require a few seconds of holding it down before it beeps. Your refrigerator ice maker is now reset!
Appliances do not have a reset button on them - to reset any appliance you UNPLUG the unit from the outlet for 3 minutes - plug back in - or turn off breaker to outlet and appliance for that long - then turn back on. That will reset the control computer board and reset the appliance.
Turn off the refrigerator and freezer from the control panel. After unplugging the refrigerator, turn off the fridge and freezer using the control panel inside the fridge. To do so, set the controls to “zero" or switch them off entirely. Once you're done, you can plug your refrigerator back into the wall socket.
Resetting the refrigerator is a simple process that can help the compressor get back on track. A quick reset can be effective for anyone looking to adjust fridge temperature or resolve other functionality issues.
Step-by-Step Reset (power cycle without reset button):
Turn off ice maker. Unplug the power cord from the outlet. Wait at least 5 minutes.