Access the lid lock switch by unplugging your washer from the wall and turning off the water. Press a magnet against the lid lock mechanism for a quick, easy way to bypass the lid lock. Cut the 1st and 3rd wire (or 1st and 4th wire if there are 4 wires) that attach to the lid lock to permanently bypass it.
Press the "control lock" button for three seconds. The door should unlock. If the control lock button doesn't work, try the "end of cycle" button to reset the washer. If the above steps fail, completely reset the machine by unplugging it for an hour.
So the first thing to do is unplug the washer for 60 seconds and see if the latch will reset. If not, leave the washer plugged in for 20 minutes. If you hear a motor running/humming, after 20 minutes the washer should unlock and reset on it's own.
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
Cycle power to the control to reset the washer:
If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in.
Normally waiting for the cycle to end is all you need to do to unlock the door, or turn your washer on if it's off. If you get stuck, though, you can drain the water from front load washers using the emergency drain hose; once the water is gone, the door will unlock.
The most common cause of a Whirlpool washer door being locked and not being able to open is a faulty lid switch (including the striker). The door switch locks and unlocks your door depending on which stage your wash cycle is at. When it becomes defective, your washer door may not unlock when it's supposed to.
A start button on your washer's control panel not working despite the rest of the lights coming on is the most common Whirlpool washer issue you will encounter. Taking off the control panel to try and find the cause will let you see if the solution can be DIYed, or a professional needs to be called.
To remove a lock washer, use a wrench or a similar tool to remove the nut or threaded fastener that holds the lock washer in place. Next, use a flathead screwdriver to pry the lock washer loose. If you remove a split washer, place the screwdriver head under the washer or inside the split.
If the plug is difficult to reach, or is hard-wired to the power supply, shut it off at the breaker. 2. Wait for a minute: Wait for 1-5 minutes before plugging the washer back in to reset the internal systems. This allows any residual power to clear and can help reset the door lock mechanism.
Turn off the machine for 5-10 minutes and try opening it again: This method works in most cases when the door lock is stuck. Turning off the machine for a few minutes gives it time to reset and release the door lock. After a few minutes, try opening the door again.
For top-load models, reset by turning the cycle selector knob to the "Normal" position. Then, turn the knob counterclockwise for one click, clockwise for three clicks, counterclockwise for one click, and finally clockwise for one click. Press the start button to complete the reset.
Turning off the machine at the mains should allow the door lock to cool down, and after a few minutes, you'll be able to open the washing machine door. The interlocks can take some time to release at the end of the cycle, so be patient. The most common cause is water left in the machine. Try running a spin/drain cycle.
If you want to try resolving issues with your washing machine, such as power surges or error codes, it's possible you might need to perform a quick reset. One way you can reset a washer is by unplugging the unit for at least one minute, then plugging it back in and restarting the appliance.