How do I know when the batteries are running low on my Smartclode 909/910 deadbolt? There are two low battery indicators on the unit. The LED light on the interior side of the lock will flash red when the batteries are low. The keypad will also flash red when the batteries are low.
Replace batteries with new ones to ensure that lock is properly powered. Typical battery life based on 10 entries per day is 10-12 months if the door is properly aligned and the lock does not encounter interference in lock/unlocking the door. 4.
What Do The Different Colored Lights On The Status LED Mean for my Premis Lock? Amber flashes mean it is locked, while green flashes mean it is unlocked, and red means low battery.
Check door alignment. Even the slightest misalignment between the door bolt and the strike plate hole can cause increased friction, which requires more power to successfully lock and unlock. This is by far the most common contributor to decreased battery life and should be assessed first.
My Keypad Is Unresponsive
Test each button on the keypad (one at a time), and listen for a beep as each button is pressed. If beeping is not heard on all buttons, replace the batteries. If battery replacement does not solve the problem, contact Kwikset Support at 1-866-863-6584.
Make sure the User Code is correct and that the Kwikset button is pushed after entering the User Code. If the door still won't unlock, use a key to unlock the door. Call technical support for further troubleshooting.
For a simple fix, try applying powdered graphite or a dry Teflon lube spray to the keyhole to get the lock moving. Exterior doors, which are exposed to the elements, may benefit from a commercial lock cleaner sprayed into the keyhole to dissolve dirt or debris.
Your Smart Lock will give you low-battery warnings for multiple weeks before it loses power. However, if your Smart Lock dies entirely before you can replace your batteries, your key will still work. This is the same deadbolt key that you've always used - the Smart Lock doesn't change the key needed.
Program at least one user code and test the Lock button again. The battery is too low to lock the door. This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.
The lock should beep twice when it unlocks and once when it locks. It will also beep if there is a warning such as a low battery or a jammed bolt.
Remove battery pack. 2. Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red.
Orange flashes indicates lock is in the middle of a programming sequence.
2 Kwikset: Factory Reset
Slide up the cover to open the back of your lock, exposing the buttons beneath. Push and hold the reset button for 10 seconds, until the lock beeps. The light ring will flash red, then spin amber. The lock has now been restored and is ready to be set up again.
No, user codes will not be lost if the batteries die or are removed.
The recommended batteries to use in your Door Lock are AA alkaline, non-rechargeable batteries. Make sure there are no lithium NiCad batteries in use.
Your door handing code has not been entered. Enter door handing code and test lock on page 7 here.
A flashing red light on your Smart Lock indicates that your batteries need to be replaced. To resolve this issue, replace your existing batteries with a fresh set of 4 brand new AA Alkaline batteries. It is important to replace all 4 batteries at one time.
A red light means the device has a low battery.
Several factors play into how long your batteries will last, including environment, temperature, and weather stripping. Typically, battery life ranges from 6 months to 1 year.
The lock/unlock signal receiver in the vehicle will be fed from the battery and would no longer work if the battery is dead or disconnected. This, however, doesn't mean the car just unlocks or anything crazy if the battery dies.
If the door lock relay has any internal or wiring issues, it can cause the door locks to function intermittently. The door locks may function correctly one moment, and in the next will cease to operate. This can be an inconvenience to the driver when trying to lock or unlock the vehicle.
The simple answer to that is, no. It is not safe to leave your keys in the back of the door, and if you are one of the people who do, you need to rethink your security habits.
Researchers say it's all about being afraid of losing control. Share on Pinterest Are you quite sure you've locked the door? If you need to check repeatedly, it may all be about your fear of losing control.