If unsuccessful, the Kwikset button will flash red 3 times and you will hear 3 beeps. Note: If the lock is muted, you will not hear the lock beeping. Delete User Codes:The lock is pre-programmed with a default User Code of 1-2-3-4.
Find the reset key in the back of the smart lock
Open your door with the fingerprint or your key, and slide up the cover to open the back of your lock, exposing the buttons beneath. You can see a small button near the battery. Just like the below image, the reset button is on the top-left of the battery.
Press and hold the Reset button for 5 seconds, until you hear 3 long beeps.2. Enter the default Mastercode (O-O-O-0).3. Press the lock button. You will hear one beep.4.
1) A programming code enables you to make changes without needing to access the programming button. This is ideal for landlords to allow programming from the outside, without access to the interior program button.
You can identity the type of Kwikset lock you have by locating a small vertical slot on the plug. This is located to the left of the cylinder's keyway.
While similar products Kwikset 913 Smartcode Electronic Deadbolt and Kwikset 909 SmartCode Electronic Deadbolt having this feature, Kwikset 264 Contemporary Keypad Deadbolt is again staying one step behind when compared to these locks. You can still have it rekeyed by a locksmith.
You will hear 3 long beeps after the 5 seconds is completed indicating the lock has been reset. A User Code is used to unlock the door while a Mastercode is a password for making changes to the lock features. Interior of door You will reset your User Code to 1-2-3-4 and Mastercode to 0-0-0-0 when the reset is complete.
Because most of the default code of the keypad door lock are very simple when they are set at the factory, either 00000 or 1234, which can be easily deciphered by strangers, it is very important to change a use code that only you know and is not easy to be guessed by others.
Deleting a user code In order to delete a user code, you must override the code by adding a different user code in the same position. For example, if you want to delete the third code, add a different user code in position three. NOTE: Test the old user code to make sure it can no longer unlock the door.
The Deadbolt Does Not Lock The Door And Kevo Convert Beeps/Lights Up Red. This is a 'bolt jam' alert. It means that Kevo Convert was unable to extend the deadbolt and your door was not locked. This happens when the door was not shut properly and the deadbolt could not fully extend into the strike hole.