Running your filter after shocking your pool is a must and is just as important to your pool as shocking it is. Be sure to run your filter for at least 6 hours, but shoot for 24 hours to several days, if your pool is particularly dirty or has algae, to properly circulate the chlorine and clean the water.
It all depends on the type of pool and the chemical levels in the pool. Your pool can keep running for a few days with no problems while without a pump. However, know that a standard pool needs a pool running for at least once in 24 hours, or you might notice an algae bloom.
Pump / Filter Status – Your pump and filter should be in place when adding chlorine to your pool. Keep your pool pump running for at least 8 hours (up to 24 hours) after adding chlorine to make sure the it is properly circulated around your pool.
Vacuuming After Shock
Shock the pool with either the liquid or granulated chlorine shocks. Let the filter run for 24 hours before adding any other chemicals.
Answer: After shocking the pool, it will need filtration and circulation. Run the pump as much as possible. Keep the filter clean (daily) until the water runs clear. Be sure to brush the pool often during this process as above-ground pools do not have drains at the bottom.
Never close the cover immediately after shocking the pool. It is recommended to wait several hours before closing the cover. Use a test kit to regularly test the pool water. If the tests results are good, this does not imply the water chemistry was good prior to your current test results.
Before you start pouring shock in the pool, the first step is to brush the sides and floor of your pool to loosen all the algae. Doing this breaks the skin and allows the pool shock to more easily kill the algae. Once you've done this, it is important to make sure you have the proper pH level in your water.
The best time of day to shock your pool is in the evening. This is because the sun's rays can affect the effectiveness of the chlorine by dissolving it too quickly, before it has a chance to rid the pool of contaminants and clean the water.
After Shocking Your Pool
It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours. It is always best to test first!
Never pour pool shock into the skimmer, pre-dissolve for use in vinyl liner pools. When broadcasting shock across the surface, be mindful of the wind direction. Brush the pool after shocking, and filter the water for at least 8 hours afterward.
Shocking your pool isn't necessary, although, it's not a bad idea either. If you get an extremely heavy rain fall, you could shock your pool for good measure. This will help fight off any contaminants that the rain may have brought to your pool.
Adding more chlorine to your pool will kill bacteria, pollutants and any other unwanted organisms in the water. Most people wait until they have a cloudy pool or pool algae to shock their pool. However, adding shock to your pool on a regular basis can help you avoid pool water problems.
Shock is liquid or granular chlorine. You should add one gallon (or one pound) of shock per 10,000 gallons of pool water every week to two weeks. During hot weather or frequent use, you may need to shock more frequently.
Pools can immediately turn green after shocking when they have metals like copper in the water. These metals oxidise when exposed to high levels of chlorine which makes the pool water turn green. Adding a metal control product such as Zodiac Metal Remover will help to restore the pool water.
You should cover your pool every night for several reasons. First off, a pool cover saves energy and conserves water by decreasing the amount of make-up water. Also, it reduces the consumption of chemicals, and finally, it saves a lot of cleaning time since it keeps the debris out of the pool.
Is It Safe To Run The pool Pump With The Pool Cover On? It is safe to run the pool pump and filter with a swimming pool cover on. The pool cover doesn't in any way stop or hinder the pool pump from circulating the water or carrying out its function.
Maintaining chlorine levels of 10ppm or higher for extended periods of time can not only ruin your liner and cover but also severely damage your pool equipment. Chlorine should be maintained ideally between 1.5ppm to 3ppm.
You want some clear area between the edge of the pool and the cover to pour chemicals. You don't need to remove the cover, you just need enough room so you aren't splashing any full strength chemicals on the cover. When you are done with the chemical addition you can pull the cover back into place.
Pool water turns green because of algae in the water. Algae can grow rapidly, particularly when it's warm like Summer, which is why it can surprise you overnight. This generally comes down to an imbalance or lack of chlorine in the water.
Running your pool pump during a lightning or electrical storm should be avoided as a power surge or nearby lightning strike could damage your pump. However running your pump during is beneficial. The extra filtering will help clean out the impurities rain has introduced into your pool's water.
Give your pool a good shock treatment 1 to 2 days before the storm hits. You can bring the chlorine level up pretty high to prolong the pool being depleted of chlorine.
One heavy rain is all it takes to throw off your pool's chemistry by unbalancing the pool water's pH and making it slightly more acidic. This additional acidity and nitrogen provide a breeding ground for algae that will turn your pool green.
Light Green or Teal Pool Water:
In this case, you should double shock your swimming pool water. To double shock, you will need to add 2 pounds for every 10,000 gallons of water. For instance, if you pool is 20,000 gallons, you will add 4 pounds of shock.