Once you have finished using disinfecting wipes on a food preparation or eating surface, make sure you rinse the surface with potable water and then dry off with a towel. This should also be followed for children's toys and objects they may put into their mouth.
(B) EPA registered disinfectant wipes for non-food-contact surfaces. The wipes should be used so the surface remains wet for a 4-minute contact time*. Following the contact time, the surface should be rinsed thoroughly with potable water if contact with food is likely.
Yes, you should wash your hands after using Clorox wipes. While Clorox wipes are designed for cleaning surfaces and contain disinfecting agents, they may also contain chemicals that can irritate your skin or be harmful if ingested.
Don't rinse the Lysol off. Just let it dry.
Usage. Spray 4–6 inches from surface until thoroughly wet. Let stand 30 seconds or longer. Wipe with a wet sponge or cloth and rinse with water.
Disinfecting products are designed for use on hard surfaces and are not meant to be used in or on the human body.
Allow the surfaces to stay wet with the disinfectant for the appropriate amount of time. If you are using disinfecting wipes, allow the surfaces to air dry. After allowing the disinfectant to set, rinse all the disinfected surfaces using clean water and a cloth or paper towel.
A: If you are cleaning surfaces contaminated with germs, I would definitely wear gloves no matter what. But just using wipes for surfaces in general cleaning, I don't wear gloves.
The active ingredient is the 'backbone' of the formulation. Most disinfection products have a formulation based on a Quaternary Ammonium Compound, also known as 'quats'. However, quats can leave a harmful residue on the surfaces, making them unsuitable for food prep areas.
While using them gives the appearance of cleanliness, it actually causes unintentional damage to the countertop after prolonged use. This happens because of the presence of citric acid in the Clorox wipes, which causes a quartz countertop to lose its color.
Clorox surface wipes may cause a little bit of irritation and redness after a while, if used on skin. Other than that there are no real toxic effects and you should be fine.
Some wipes, like the kind made with benzalkonium chloride, are only approved to kill bacteria. They might not work as well on viruses. Wipes with “disinfectant” on the label should kill bacteria, viruses, and mold.
YES! Remember, if you are disinfecting a surface, it is because the surface is likely dirty or contaminated with pathogens, and these can contaminate your hands too, which can then be transferred to other surfaces, where they may make you or others sick.
There are two health risks most commonly associated with disinfectant use: respiratory issues like asthma and potential reproductive harms. Lung irritation, asthma, and allergies. Bleach is well-known as a possible cause of asthma, and quats have also been found to have the potential to set off the condition.
Precautionary statements P102 Keep out of reach of children. P264 Wash contaminated skin thoroughly after handling. P280 Wear eye protection. P302+P352 IF ON SKIN: Wash with plenty of water.
If used on surfaces that are in contact with food, remember to rinse after use. Where can I buy Clorox® Disinfecting Wipes?
Disinfecting Wipes are NOT Skin-Friendly
Sanitizing and disinfecting wipes are fine to touch while you're cleaning with them, but they should never be used to clean hands or other body parts.
The germ-killing ingredient on disinfecting wipes is a chemical pesticide, so you shouldn't use them directly on your skin. You also shouldn't use them on food (for example, don't clean an apple with one before you eat it).
Once you have finished using disinfecting wipes on a food preparation or eating surface, make sure you rinse the surface with potable water and then dry off with a towel.
Toilet Seats
Diluted multi-surface cleaners (Mr. Clean®, Pine-Sol®, etc.) or chlorine-free disinfecting wipes (Lysol®, Clorox®, etc.) can be used. Rinse your seat with a damp cloth and dry with a soft towel.
Clorox and Lysol both utilize Alkyl dimethyl benzyl ammonium chloride in their wipes. Alkyl dimethyl benzyl ammonium chloride, more commonly known as Benzalkonium chloride, has a wide range of applications because of its broad-spectrum antibacterial properties against bacteria, fungi, and viruses.
One term commonly used with regard to sanitizers is “post rinse”. Post-rinse sanitizing mean that rinsing is not required after the sanitizing step (when the sanitizer is used at an appropriate concentration and then properly drained).
After disinfection with bleach solutions, surfaces should be rinsed and dried.
“The longer you allow the sanitizing solution to remain in contact with the surface, the more germs you'll kill. Different products suggest different ideal timeframes to let the product sit, but to kill 99.9% of viruses and fungi on nonporous surfaces, you often need to let the disinfectant sit for 5-10 minutes.”