The dead algae is likely too fine to be vacuumed through your sand filter, therefore owners of sand filters must vacuum on the waste setting. Cartridge filter owners can vacuum up the dead algae but need to clean the filters thoroughly after doing so.
Unfortunately, sand filters have a higher micron count and take much longer to clear a green pool, especially if there is no main drain. The water would need to be continuously stirred up to be able to filter it through the surface skimmer.
If you suspect swimming pool algae is making your pool water green or cloudy, check the water's alkalinity and pH balance. This is the most common cause of green pool water. Unfortunately, algae can become resistant to chlorine and sanitation because of the water's pH and alkalinity.
Where Did The Algae Come From? For the most part, a lack of chlorine in the pool is usually the starting point of any pool turning green. Chlorine is the primary chemical we use to disinfect our pool water from germs and other contaminants. Algae grow as the disinfecting power of the chlorine in your pool diminishes.
Pool water turns green because of algae in the water. Algae can grow rapidly, particularly when it's warm like Summer, which is why it can surprise you overnight. This generally comes down to an imbalance or lack of chlorine in the water.
Set up your waste line and vacuum the pool to waste getting the algae and debris out of the pool. Don't let the water level get too low during this process, if it gets more than 6 inches below the tile, stop. Turn the system off and refill the pool and repeat until the whole pool is vacuumed.
A nylon or rubber brush is the correct choice for scrubbing the sides of a soft-sided above-ground pool. A large pool brush makes quick work of the job, but you may need a smaller brush to clean corners. Once the particles have been removed from the sides of the pool, turn your filter back on and agitate the water.
Vacuuming algae through the filter can be less effective and a big headache as you'll need to clean out the filter multiple times during the process. As for vacuums themselves, the robotic kind are the best ones for this job as you just turn them on and let them do their thing.
Should the green be due to pollen, there may be little to do in the way of minimizing the discoloration short of erecting a building around the pool. Fortunately, assuming there are no allergies to the pollen, it is safe to swim in a pool with that as the cause for green water.
When the levels are properly balanced, chlorine will keep the algae at bay, but the water will slowly begin to turn green as the algae take over if there's not enough. But be careful—adding too much chlorine in pool water can cause those metals to oxidize and turn the pool a different shade of green.
What happens if too much shock is added? You cannot overshock a swimming pool or add too much. Adding too much shock or overshocking your pool will kill off algae. The negative of adding too much shock is it will upset the chemical balance of your pool.
Light Green or Teal Pool Water:
This means there's a low amount of algae in your water and you won't have to use a hefty amount of chlorine shock. In this case, you should double shock your swimming pool water. To double shock, you will need to add 2 pounds for every 10,000 gallons of water.
Pools can immediately turn green after shocking when they have metals like copper in the water. These metals oxidise when exposed to high levels of chlorine which makes the pool water turn green. Adding a metal control product such as Zodiac Metal Remover will help to restore the pool water.
It's pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn't be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.
It's often recommended to shock your pool once a week. If you don't do it every week, you should at least do it every other week. This is necessary to maintain your pool's water chemistry. If you have a lot of people over in your pool or have a party, you may want to shock your pool more frequently.
After Shocking Your Pool
It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours. It is always best to test first!
"Heavy rain dilutes pool chemicals, especially salt and chlorine, which causes the pool to turn green. This means the water is not sanitised or healthy, so it's vital to address this.
The use of baking soda in pools can spot treat algae
No one ever wants to see algae build up in their swimming pool. It can turn any backyard pool murky green or cause unsightly black spots on the walls and floor of any swimming pool.
Tadpoles can be released close to your home, even in an non-chlorinated, decorative pond in your back yard. Tadpoles turn into frogs, however, and eventually those frogs lay eggs. It is possible they will lay eggs in your swimming pool.
1. Shock the pool with chlorine every day until all the green is gone (possibly 3 to 4 days). 2. Run the filter 24 hours a day and backwash every day until the green and then cloudiness is gone (usually up to 7 days, sometimes as long as 2 weeks depending on the filter).
A great way to determine if algae is present in your pool is by identifying what the pH levels of your water are. If the levels are too high, it's likely that algae could begin to grow. For basic monitoring, you should consider the pH1000 sensor, which is designed to be used with pools.
Dead algae turns white or gray in color and falls to the bottom of the pool. If you are using a chlorine shock product with a clarifier, the water will be crystal clear, leaving you a good view of the problem below.