When your freezer display is not working, a malfunctioning electronic control board could be causing the problem. The electronic control board receives electrical power from the power cord or power supply board and sends signals to the control panel.
* Unplug the freezer from the electrical outlet. * Wait for approximately 30 seconds to 1 minute to ensure that any residual power dissipates. * Plug the freezer back into the electrical outlet. * Turn the freezer on using the control panel or power button.
The most common reasons your Frigidaire refrigerator display is not working are a defective electronic control board, bad LED light assembly or an inoperative user interface.
On most phones, press your phone's power button for about 30 seconds, or until your phone restarts. On the screen, you might need to tap Restart .
Press all buttons on the Frigidaire refrigerator control panel to check if the user interface control board is faulty. If certain buttons fail to respond while others work normally, the control board likely needs replacing. Also verify the display is functioning - a blank or frozen display indicates board failure.
Use the Reset Button or Crush Button on Your Frigidaire Fridge. First, check if your fridge has a Reset button on the control panel at the front of the fridge. Once you have located it, press and hold the button for 5 seconds. If there is no Reset button, press and hold the Crush button for 5 seconds instead.
If your freezer light isn't working, it could be similar to fixing a refrigerator light. Make sure your appliance hasn't been unplugged and the outlet is working. Frost buildup can also cause a door switch to not function properly. Use a warm, damp cloth to melt any frost that may be hindering the door switch.
Check to see if the bulb is burned out, and if it is, replace it with an appliance bulb of the same wattage. If the bulb isn't burned out but the light is still off, there might not be electricity running to the freezer. If this is the case, the safety signal light outside the freezer will also be off.
Reset your refrigerator: First, unplug it (or turn off the power at the circuit breaker), and then wait about five minutes for the electrical charge to clear out of it. Then, power it back on again.
The most common reasons your Frigidaire freezer is not working are a failed compressor, malfunctioning electronic control board or a faulty condenser fan motor.
If some of the buttons work, but others do not work, the user control and display board might need to be replaced. Additionally, if the display is not working, check the power to the user control and display board. If the user control and display board has power, but it isn't working, replace it.
Frigidaire refrigerator control panel reset
Unplug the refrigerator from the power source or turn off the circuit breaker that supplies power to the appliance. Wait for a few minutes to allow the control panel to reset. Plug the refrigerator back in or turn on the circuit breaker.
The control board is one of the most expensive refrigerator parts to fix, at between $80 and $800, because no part of the appliance can function without it. If your fridge has completely stopped working, it probably has something to do with your control board.
A simple reboot can resolve many issues almost immediately. Restarting the computer is an effective way to clear the memory (RAM) and ensure that any errant processes and services that have started are shut down. Restarting the computer closes all the applications and software that are running on the computer.
If some of the buttons work, but others do not work, the display board might need to be replaced. Additionally, if the display board is not working, check for power to the display board. If the display board has power, but it isn't working, replace it.
Clean the touch screen and screen protector. Sometimes, a touch screen will stop responding due to built-up dirt and grime or problems with the case or screen protector. Since this is pretty easy to either deal with or rule out, it's a good idea to thoroughly clean your device if a reboot doesn't do the trick.
The temperature of a freezer should be set at 0 degrees Fahrenheit so everything stays very cold. A freezer should be cold enough to keep food frozen and preserve it until they are ready to be cooked or reheated.
Try resetting the control panel by turning off power to the refrigerator briefly. Unplug the refrigerator or turn it off at the circuit breaker for 30 seconds to reset the control.