Which gases are used in AC? R290 and R32 are both gases used in air conditioning units. They're also known as refrigerants, which means they help cool down your room by turning into liquids when pumped through the system. Compared to other gases such as R12, and R22, they are safer and environment-friendly to use.
R410A, R22, and R32 are the most common refrigerant gases used in AC. However, R600A (Isobutane) and R290 (Propane) are some of the environmental friendly refrigerants available on the market.
If your unit was manufactured past 2010, you may have more economically wise repair options available. Manufacturers, after this date, incorporated R-410a, or Puron, as an alternative. Units that were manufactured before the year 2010, generally used R22 refrigerant.
The Takeaway. In most cases, R32 is the superior refrigerant when compared to R410A. While neither refrigerant depletes the ozone layer, R32 has a lower GWP and is easier to recycle. R32 also has lower operating and maintenance costs and is nowadays more common than R410A due to the phase-out.
As Freon was phased out, new HVAC systems began using a refrigerant known as Puron® or R-410A, an HFC. More efficient and less harmful to the environment, R-410A has been in use since its introduction in 1996 and is found in most of today's modern HVAC systems.
R-32THE MOST BALANCED REFRIGERANT.
R-410 refrigerant costs $60 per pound on average, but can range from $40 to $75. Keep in mind you cannot purchase R-410A refrigerant without an HVAC pro. As of mid-2024, R-410A refrigerant prices range from $40 to $75 per pound.
No. R32 is not suitable as a drop-in replacement for R410A and must only be used in systems specifically designed for R32.
R-410A PHASE-DOWN TIMELINE
We will reach a 70% decrease by 2029. In 2034, we will see 80% less R-410A being produced than it is today, and the phase-down will end in 2036 with another 5% reduction.
Currently, the price for recharging an air conditioning system with R-410A is around $90 per pound. Comparatively, the cost to recharge an older system that uses R-22 refrigerant is now around $250 per pound.
The pressure can become high enough for parts of the system to rupture. At the very least, leaks will occur.
R32 is the newest and most popular air conditioner refrigerant gas. This is because of its relatively high efficiency and low GWP (Global Warming Potential). R410A is also popular, but its higher GWP means that its more harmful to the environment.
The most commonly used refrigerant in air conditioning systems is Puron, more specifically R-410A. This refrigerant is a non-toxic, non-flammable gas that lacks odor, so when your unit springs a leak, your nose might not alert you to the problem.
Check the under bonnet label. Open the bonnet of your car and look for a label or sticker on or near the air conditioning system components. The label may provide information about the type of refrigerant used. It is often located on the compressor, accumulator or engine bay area.
In 2024, we will see wider adoption of low GWP refrigerants such as R-32, which has only one third the GWP of R-410A. Other options like propane (R-290) and ammonia (R-717) are also gaining popularity as natural refrigerant alternatives. These will allow AC units to have a much lower carbon footprint.
As a solution, there are two alternative refrigerants used as substitute refrigerant for R22, namely R290 and R32. The R290 is widely used as working fluid in A/C system of Europe countries; meanwhile in Japan and South East countries, R32 is utilized as substitute refrigerant for R22 and R410A (Yu et al., 2010).
Why R-410A Is Being Phased Out. Because R-410A operates at such high pressures, there is an increased risk of an environmentally harmful refrigerant leak during maintenance and repair work. The R-410A phase-out means new HVAC systems will use more sustainable refrigerants.
R410a is actually a blend of two different refrigerants, one of which is called R125. There's currently a world shortage of R125 because there aren't enough plants to produce it. Without enough R125, producers can't make enough R410a to keep up with the increasing demand.
Starting January 1, 2025, all new residential air conditioners and heat pumps must utilize A2L refrigerants. Older refrigerants like R-410, which are likely the refrigerant used by your current system, are being phased out. These new systems are designed to have a lower global warming potential (GWP).
R32 is a single gas, not a combination of two varieties. For this reason, it costs up to 30% less per kilogram than conventional refrigerants like R410A. Energy-efficient.
Changes to the Dangerous Goods Legislation, effective in 2021, has new categories for A2L refrigerants. R32 is a synthetic greenhouse gas. If released to the atmosphere it can contribute to climate change. R32 is a flammable refrigerant.
How much will an R-22 to R-410A conversion cost? The actual cost will depend on many things, including where you live, but most of the time R-22 conversions start at around $2,000 and go up from there. The higher end of that range is somewhere around $4,500 to $4,600.
A three-ton air conditioner would typically have six to 12 pounds of refrigerant for a proper charge.
RS-53 (R470A) enables users to replace R410A in existing units with minimal changes and inconvenience at low cost.
R-454B is the newest refrigerant, which will gradually replace R-410A, the refrigerant used in current HVAC manufacturing. R-454B is a blend of R-32, a hydrofluorocarbon (HFC), and R-1234yf a hydrofluoroolefin (HFO).