While the door is open, press the “Program” keypad button located on the interior side of the door. Enter a four to eight digit security code that you can easily remember on the outside electronic lock keypad.
Because most of the default code of the keypad door lock are very simple when they are set at the factory, either 00000 or 1234, which can be easily deciphered by strangers, it is very important to change a use code that only you know and is not easy to be guessed by others.
Make sure the batteries are installed, and bring the interior assembly next to the controller. Follow your smart home system's instructions to begin pairing at the controller. The lock may need to remain stationary for 60 seconds during pairing.
Check that the bolt hole is at least 1” deep so the bolt fully extends. Check that the door closes properly so that when the deadbolt is extended, it is going into the bolt hole and not hitting the deadbolt strike or door frame. Check that the mounting screws securing the exterior keypad are not over-tightened.
1) A programming code enables you to make changes without needing to access the programming button. This is ideal for landlords to allow programming from the outside, without access to the interior program button.
Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). 2. Enter new Mastercode.
Key codes are found on the side or the bow of the original key that came with your new lock. Some brands do not stamp this code on the side of their keys. If this is the case the only way to get that code is with a key gauge.
A code preventing the unauthorized use of a mobile phone. the user isn't given access to the phone without entering the right sequence of numbers using the keypad.