When should I start getting my pool ready?

Author: Kelly Cartwright  |  Last update: Friday, July 1, 2022

7 Steps to Get Your Swimming Pool Ready for Summer
From start to finish, opening your pool and getting it ready for warmer weather takes all of about an hour. That said, it's best to wait at least 24 hours after shock treatment to actually swim.

What month is best to set up a pool?

SPRING: MARCH - MAY

The typical 'pool season' starts to kick off around Spring break (mid-March). During the spring months, you will typically see standard above ground pool pricing.

Is it too early to open pool?

Opening early does mean the cost of an additional month or two of maintenance and balancing chemicals. However, it is far easier and a lot less expensive to maintain a clear pool than to clear up a green one!

Is April too early to open pool?

Earlier is Better

When it comes to opening your pool, sooner is better than later. There are no set rules for pool opening, and the exact time highly depends on your region of the country. Mid-March is fine after a milder winter, while April is better after a colder season.

How soon can you swim after opening pool?

Chlorine/non-chlorine chemicals – When adding chlorine or non-chlorine chemicals to “shock” your pool after a fill-up, wait about 24 hours or until levels are approximately 5 ppm. If you'll only be adding liquid chlorine, it's generally safe to swim after about 4 hours or until levels are 5 ppm or lower.

When Is The Right Time To Open Your POOL? | Swim University

Is it cheaper to put in a pool in the winter?

Is it cheaper to build a pool in the winter? Yes, it's often cheaper to build a pool in the winter because most people book their pool construction for the spring and summer months. Because of this, many pool builders are likely to offer discounts throughout the off-season.

How do I get my pool ready for summer?

5 Tips To Get Your Pool Ready For Summer
  1. Don't empty the pool. This is especially important if your pool sits on a high water table. ...
  2. Give it a clean. Give your pool a thorough “chemical open” before use. ...
  3. Top off the water. ...
  4. Get your water professionally tested. ...
  5. Wait for the water to appear completely clear.

When should I open and close my pool?

If the weather in your area still has the potential to peak into the high 70s or low 80s, you will want to keep your pool open and maintained normally. It is best to close your pool when the temperature of the water is consistently below 60 degrees.

What is the best temp for a pool?

Keep Swimmers Comfortable

Set your pool heater's thermostat to a temperature between 78°F and 82°F (26°C and 28°C) to keep the majority of swimmers comfortable. Maybe a little cooler if you're in an area with very hot summers, or a little warmer if you live in a milder climate.

Can I open my pool in March?

BEST TIME TO OPEN POOL—MARCH AND EARLY APRIL...

When opening your pool in the early months of March and April means less chance of algae growth. This, of course, will depend if you winterized your pool properly. Keeping the pool clean and algae-free means catching it before it goes into full bloom.

What temp does algae grow in pool?

Keep your pool temperature lower

As I previously mentioned in my list of pool care essentials, having a thermometer to track your pool temperature is important because algae loves to grow in hotter temperatures––generally 85 degrees or above.

Do you have to shock your pool when you open it?

Shock your pool when you open it for the season to kill algae that has developed in the Spring. AFTER A PARTY OR HEAVY USE: People carry bacteria and chlorine levels can drop drastically when there are many active swimmers using a pool.

Will chlorine clear a green pool?

Shock Your Pool with Chlorine to Kill Algae

This is the main event in clearing a green pool—killing the algae. Pool shock contains a high level of chlorine that will kill the algae and sanitize the pool. For the best results, use a shock that contains at least 70% available chlorine (calcium hypochlorite).

What order do you put chemicals in a pool?

What Chemicals to Add When & Why
  1. Start by Testing Your Water. The first thing that you should do before you start adding chemicals is test the water. ...
  2. Alkalinity Levels. ...
  3. Manage pH Levels: Add Muriatic Acid of Soda Ash. ...
  4. Adjust the Calcium Hardness. ...
  5. Add Stabilizer (Cyanuric Acid) ...
  6. Add Chlorine.

How much does a 12x24 inground pool cost?

12x24 Inground Pool Cost

The cost for this size, on average, will be between $26,000 and $38,000, depending on the type of material used. Materials and their average associated costs are as follows: Concrete, $38,000. Fiberglass, $34,000.

What do you do with a pool cover when it rains?

Many areas have wet or rainy seasons. During these times, you can leave your pool cover pump on your swimming pool cover and let the pump work for you. Every time it rains, the cover pump will automatically activate and evacuate the water when a certain amount collects by the pump and then shut itself off.

Do pools add value to a home?

Does an inground pool add value to a home? An inground pool will make an attractive home more valuable, especially if the home is higher priced and in a neighbourhood with a large number of backyard pools. On average, a pool will add a six percent increase to the resale value of a home.

Can I swim in a green pool?

What's important for you to know: You shouldn't swim in a pool that's green until you test the chemical levels, like the officials in Rio did before the diving event began. It's the balance of things like chlorine, pH, and alkalinity in a pool that keeps it sterilized.

Can algae grow in a pool with high chlorine?

So if the pool water isn't cloudy and the 'dirt' is clinging to the walls after brushing, the problem is likely be yellow/mustard algae. Yellow/ Mustard algae is very resistant to even high chlorine levels and will grow and thrive in a chemically well-balanced pool.

How often should I brush my pool?

Brushing thoroughly 1-2 times per week will prevent these materials from having the time to create a stain. Brush to Prevent Algae: Every pool can grow algae, but plaster, quartz, and aggregate finishes are more susceptible.

How often should I put chlorine in my pool?

Shock is liquid or granular chlorine. You should add one gallon (or one pound) of shock per 10,000 gallons of pool water every week to two weeks. During hot weather or frequent use, you may need to shock more frequently.

What is the difference between shock and chlorine?

The main difference between Shock and Chlorine is that the shock is a high dose of chlorine, whose only function is to shock by raising the chlorine level in the swimming pool. On the other hand, Chlorine is a general sanitiser used to maintain a crystal and clear pool for swimming.

What happens if you over shock your pool?

What happens if too much shock is added? You cannot overshock a swimming pool or add too much. Adding too much shock or overshocking your pool will kill off algae. The negative of adding too much shock is it will upset the chemical balance of your pool.

When should I open my pool to avoid algae?

A late September or October closing is a great way to set up for success in the spring. If you are already suffering from an algae bloom; take care of that before you close. Opening your pool early in the spring is a good idea if you want clear water.

Does covering a pool prevent algae?

Keep it covered.

Covering the pool is a good way to prevent algae growth. The right cover keeps algae from entering the pool, but it also keeps leaves, bugs, bacteria, and dirt from decomposing in the pool, providing algae with food.

Previous article
Can I add salt and chlorine at the same time?
Next article
How do you keep outdoor carpet from molding?