4.2 Explosion and fire hazards White spirit is flammable and presents a moderate fire and explosion risk, especially when exposed to heat or flame. Depending on the grade, the flashpoint can lie between 21 and 55°C or higher.
Liquor that contains 40% ABV (80 US proof) will catch fire if heated to about 26 °C (79 °F) and if an ignition source is applied to it. This temperature is called its flash point. The flash point of pure alcohol is 16.6 °C (61.9 °F), less than average room temperature.
Breathing in white spirit vapours may cause irritation of the nose, throat and lungs, shortness of breath, stomach upset, dizziness, headache, lack of coordination and drowsiness. Exposure to very high concentrations via inhalation may cause symptoms similar to those seen following ingestion.
Ethanol has a flash point of 14 °C (57 °F), meaning it will catch fire at and above that temperature given an ignition source such as an open flame a spark, or even just a hot surface. o 70% ethanol in water, a common concentration in labs, has a flash point of 16 °C (61 °F) • Ethanol vapors will catch fire, so the ...
Liquid. Flash point 59.0 - 68.0 °F (15.0 - 20.0 °C) closed cup Evaporation rate Expected to be rapid. Miscible.
Any alcohol listed above 100 proof – 50 percent ABV – is straight up flammable and would therefore not hinder the ability of gunpowder to fire. Today, proof is more about labeling alcohol content in liquors for consumer safety and for taxable purposes.
Depending on the grade, the flashpoint can lie between 21 and 55°C or higher. Combustion results in the formation of carbon monoxide. White spirit forms explosive air-vapour mixtures above 21°C. Adequate ventilation should be provided and smoking prohibited.
Although white spirit and rubbing alcohol are both solvents, they are chemically different. While the spirit is a petroleum-based solvent, white rubbing alcohol is an ethanol solvent with a methanol additive. Unlike any other solvent, both rubbing alcohol and white spirits can effectively dissolve cured paint.
Sometimes called white spirit, mineral turpentine, or Stoddard solvent, mineral spirits is a purified petroleum distillate made as a substitute for turpentine.
Low Aromatic White Spirit Grades
We mainly classify low aromatic white spirit or solvent 402 in two grades A and B. Grad A: this grade is highly applied in painting buildings, draining, printing, etc. This grade has a density between 0.875 to 0.885, the minimum of the flash point is 38° C and It is not smelly.
Class II: Liquids with a flash point at or above 100°F and below 140°F (60°C). Examples: No. 1, 2 and 3 fuel oils, kerosene, and hexyl alcohol. Class IIIA: Liquids with a flash point at or above 140°F and below 200°F (93°C).
With the taste of sweet cinnamon, Flash Point is perfect for sipping, shooting, and most of all sharing. Perfect in any cocktail. Wine based product that looks, smells, and mixes like a spirit.
White spirit alternative
As you may guess now that you're an expert in paint thinners, you can use white spirit, turpentine and methylated spirit pretty much interchangeably. All of them are alternatives to each other.
Mineral oils like white spirit, mineral turpentine or lubricating oil are not prone to self-heating and will not cause spontaneous combustion. It is simple to prevent spontaneous combustion since oxygen is needed for it to occur.
How long does the smell of white spirit last? Unfortunately white spirit does have a very strong odour that is quite unpleasant, however you'll be happy to know it only takes a couple of hours for white spirit to evaporate, if it has good ventilation. When the white spirit evaporates the smell will also disappear.
It is a solvent that can dissolve certain types of plastics and rubber materials used in some types of pipes, particularly older or more brittle pipes. If white spirit is poured down a drain or sink, it can potentially damage the pipes by corroding or degrading the pipe material over time.
Clean surfaces naturally.
You can swap the rubbing alcohol for distilled white vinegar, but do not use any vinegar solution on granite, marble, natural stone or hardwood.
White spirit is made up of various liquid hydrocarbons, mainly aliphatic (paraffin) and also contain aromatic hydrocarbons (benzene, xylenes). Saturated aliphatic and cyclic hydrocarbons constitute about 85% of the content of white spirit and aromatic hydrocarbons about 15% (by weight).
Auto-ignition temperature >230°C/>446°F Decomposition Temperature Not available. Viscosity Kinematic viscosity ≤ 20.5 mm²/s. 0.95 mm2/s @ 40°C Explosive properties Not considered explosive based on chemical structure and oxygen balance considerations.
Ethanol appears as a clear colorless liquid with a characteristic vinous odor and pungent taste. Flash point 55 °F. Density 6.5 lb / gal. Vapors are heavier than air.
The flash point of kerosene is between 37 °C (99 °F) and 65 °C (149 °F), and its autoignition temperature is 220 °C (428 °F).
At 55 degrees Fahrenheit (o F), the flash point of pure ethanol (the temperature at which it produces enough vapor to ignite in air) is well below room temperature while the flash point of a liquor such as whiskey or vodka, which contain about 40 percent ethanol (80-proof), has a flash point of 79o F, which is not much ...
A Flaming Dr. Pepper is made by lighting a shot of rum and amaretto liqueur on fire before dropping it carefully into a glass of beer. It tastes just like Dr. Pepper itself, but be careful because the Bacardi 151 rum stands for 151 proof — that is why it is able to catch on fire!