The wall cleaner you'll use is safe, effective, and readily available—all you need is dish soap and salt. The dish soap cuts through grease and dirt while the salt acts as an abrasive to remove stains and grime. Combine one cup of dish soap and one cup of salt to mix a thick, gritty paste.
Do not use any abrasive household cleaning products on painted walls. Mild soap and warm water will suffice for most cleaning tasks. For tougher blemishes, gently rub a paste of baking soda and warm water over the stain.
No matter what type of paint you have on your wall, fill the bucket about halfway and never use more than a couple drops of dish detergent. Some alternatives: castile soap instead of dish detergent, a microfiber cloth instead of a sponge, and a long-handled, soft-bristled brush for hard-to-reach places.
The best solution for cleaning walls is plain warm water. To clean grease off kitchen walls, add a few drops of dish soap to cut through any accumulation. Simply dampen a sponge with your chosen cleaner and start scrubbing. The water will attract dirt, preventing it from ruining your new paint.
You can quickly clean smooth-surfaced walls with a wet Swiffer mop. It can touch hard-to-reach spots on the wall and slides easily along the corners. The primary downside is that fresh Swiffer pads can leave drips, which can leave marks and get behind outlets and light switches.
Add about ¼ cup of your favorite Pine-Sol® scent to a gallon of water. Dip a sponge, rag or cloth in the mixture and wring out until it's lightly damp. Then, start wiping down the walls from top to bottom, using Pine-Sol® at its full strength on stubborn marks. Wipe down the walls with water.
Latex-based paint responds very well to vinegar or dish detergent. Add just a few drops of dish detergent or a few tablespoons of vinegar to approximately half a bucket of water. Once these solutions have been mixed together, use a soft sponge to gently remove dirt and grime from your walls.
For tough jobs, use full strength and rinse immediately. On wood surfaces, do not allow puddles of product to remain. Pine-Sol® is not recommended for use on marble, aluminum, or unsealed, waxed, oiled or visibly worn wood.
Fabuloso® Antibacterial is an all in one cleaner that can be used for floors, walls, bathrooms, living rooms, and almost every hard surface.
“And the floor can end up sticky and even dirtier because their cleaning solvent tends to dry very fast, leaving a sticky residue if not cleaned fast and well.”
Swiffer is designed not to leave a residue and should provide a great clean on virtually any floor in your home. For best results, make sure the product is suitable for your floor. Do not use Swiffer Wet cloths or the Swiffer WetJet on unfinished, oiled or waxed wooden floors, non-sealed tiles, or carpet.
The Swiffer Sweeper floor mop is a go-to cleaning tool for homeowners with hard floors, but did you know that it's also perfect for dusting walls, too?
How Often to Clean Walls. As part of your regularly scheduled chores, painted walls should be dusted and cobwebs removed at least monthly—twice a month is even better. You should clean smudges and dirt around doorknobs and light switches weekly.
Kitchen and bathroom walls need regular cleaning. Living areas and bedrooms can probably do with an annual wall-washing, at most. Spot cleaning keeps lesser-used guest bedrooms clean for years. Kitchens and bathrooms need the most attention because moisture and oils in the air cause dirt to stick to vertical surfaces.
Overall, microfiber mops have more pros than Swiffer mops. Microfiber mops can be used as a two-in-one to both sweep and mop at the same time. However, a Swiffer mop can typically only clean after the sweeping has already been done.
While a Swiffer is a great tool for everyday cleaning (especially if you vacuum first), don't use it if there's a lot of dirt or other debris on your floors. These bigger messes might be a better job for the Swiffer WetJet, or a regular mop or vacuum.
Avoid Using Too Much Soap
Soap only lifts dirt and oil into water, making them suspend in water. Therefore, the more soap you use, the more your mop gets saturated with dirt. So, if you do not remove all the soapy water from the floor, the dirt remains, forming streaks on the floor.
How Often to Wash Your Floors With a Swiffer. Clean floors at least weekly to remove grit and grime that can leave minute scratches. Of course, clean up spills as soon as they happen. If you don't have time to wash the floor, use a dry Swiffer to sweep up loose dirt until you can wash the floor properly.
The electrostatic dust mops – also known as “Swiffer mop” in the B2C market – have a unique composition that allows static electricity to attract dust to the mop. The floor mops have tiny polyester fibres which create a static charge that attracts dirt and dust particles. These dust particles then stick to the cloth.
Mix one cup of white vinegar into a bucket of warm water, and use a soft sponge to tackle stubborn stains. You can also try using washing-up liquid and warm water. For glossy finishes, which are less durable when it comes to cleaning, avoid harsh substances and consider using heat instead.