When your oven is locked, this is a safety feature that is done during the self-cleaning cycle. As the oven gets so hot inside to burn away excess food and greases, it is a hazard. To prevent injury or other issues, the oven will lock the door until the cycle is complete.
As a safety precaution, your Samsung range's door will lock when the oven gets too hot. This is to prevent any possible injuries. If your oven is cool, then you may have Child Lock turned on or need to power cycle the range to unlock the door.
Try turning the breaker off to the unit for 60 seconds to see if it will reset. When you turn the circuit breaker on, go inside and push on the door. Hold it in for a minute or two in case it's rubbing on the door latch not allowing it to release. If that doesn't work, then try to set the self clean.
It indicates that the safety lock is activated.
One of the most common reasons locks won't open is when keys are freshly cut. If you can insert the key, but it will not turn, it is probably because the key was not cut properly. Unfortunately, in cases like these, you may need to get a new key cut so you can get into your home.
The oven will need to cool to approximately 200°F (95°C) before the door will open. Allow the oven to cool, for approximately 30-90 minutes, move the latch arm to the left to unlock the door.
Buy the "Advanced Production: Buildings" pack for 2500 Science, and you'll have the Oven recipe added to your crafting list, among others. The oven requires the following ingredients to craft: Clay x10. EverChar Coal Chunk x4.
As a safety precaution, the oven door will lock during a self-cleaning cycle. It should unlock when the cycle is complete and the oven cools down. Here's how to open the door when your Whirlpool oven door locked during the self-clean cycle: End of Cycle: Allow the oven 30-90 minutes to cool.
The oven door lock on ranges and wall ovens is designed to be used during a self-clean cycle only. If your oven has a manual lock (a door latch handle that you can slide from left to right), do not manually lock the oven when using other functions.
Turn the circuit breaker to the OFF position or remove the fuse. Wait one minute, then turn the circuit breaker back to the ON position or install the fuse to reset power to the appliance. This should reset the electronic controls on the Range or Wall Oven.
The Lock Controls feature on an Electric, Gas or Dual Fuel Range locks out the oven control panel so that pressing the pads does not activate the electronic controls. This will not keep you from using surface burners that are controlled by knobs.
To prevent injury or other issues, the oven will lock the door until the cycle is complete. In most cases where the oven door is still locked, it is because the self-clean cycle was stopped prematurely, such as when you hit it accidentally or just wanted it to stop so you could actually use your oven.
If you have a stuck door lock, spray lubricant into the lock's keyhole. Doing so will loosen any debris or deposits sitting inside your stuck lock and prevent your key from turning. Insert the key and rotate it a few times to work in the lubricant, releasing the stuck part.
Oven Door Has Been Locked Accidentally
If no food or utensils are in the oven, start a Self-Clean cycle, then hit the Clear/Off pad after 60 seconds. If that does not unlock the door, run a short Self-Clean cycle (1-2 hours).
Unplug the oven for 5 minutes, plug it back in, and press “Clear/Off”. This can sometimes prompt the oven's computer to reset and release the lock button. It's fairly common for the lock function to get stuck if the self-cleaning cycle was interrupted for any reason, like a power outage.