There are alternatives to chlorine including bromine, ionizers, and ozonators, though with each you'll still need to use some chlorine. A fourth alternative is PHMB, which doesn't require the use of any chlorine.
Common unscented household bleach (sodium hypochlorite) works well to shock a pool.
A rule of thumb is 1.5 lbs. of baking soda per 10,000 gallons of water will raise alkalinity by about 10 ppm. If your pool's pH tested below 7.2, add 3-4 pounds of baking soda. If you're new to adding pool chemicals, start by adding only one-half or three-fourths of the recommended amount.
Short answer: yes. Longer answer: it depends on the formulation. The label on every bleach bottle should tell you the ratio of sodium hypochlorite (and available chlorine) in the bottle to everything else. A higher percentage is generally better, as you'll need to use less bleach to treat your pool.
The solution to maintaining a clear pool is to use readily available liquid bleach as your chlorine source. Chlorine bleach, as discussed above, is not bound to a stabilizer, so when you add chlorine bleach to the pool, it will go right to work killing microbes and sanitizing.
I think the answer to your question is about 3-6 days. The problem is that the chlorine that you need to keep the bacteria in check is used up more quickly as the temperature rises, the activity increases, and as sweat and other body stuff is put into the pool.
The best common household items one can use to clean their pool is baking soda. Baking soda is a common household product that can be found in most average homes. Baking soda is either Sodium Bicarbonate or Sodium Hydrogen carbonate, and it's ideal for raising the alkalinity of water in a pool.
Liquid chlorine — In general, it's a good idea to wait at least four hours after putting liquid chlorine in the pool. The size of your pool and the amount of chlorine added does play a factor in this, too. Once your levels reach 5 ppm or lower, you're ready to swim.
Chlorine is a natural element and an ingredient of bleach, while bleach is a solution and the product of combining chlorine and other chemicals. 2. Chlorine exists in nature, while bleach is a manufactured product.
High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria.
Well-known member. No! Splashless contains a type of soap as a thickener, and it will make bubbles in your pool, as well as HE washing machines. Don't use splashless bleach.
Green algae, unlike its black counterpart, is a true algae; it isn't resistant to chlorine, so you can control it by shocking the pool. If you don't want to spend a lot of money on expensive pool chemicals, you can shock with household bleach.
It is possible use use the tablets in your large wading pool. However, this is not economical and it will take a large amount of tablets to clean your pool. Unless you have a major supply of these tablets on hand, I would not suggest using them to clean a pool.
Bleach is sodium hypochlorite and I was reading I can make my own bleach using a formula of 2 tablespoons of calcium hypochlorite (shock 70%) and 3 cups of water to make the concentrate. The add 8 drops of this concentrate to a gallon of water to create the standard 6% off the shelf bleach.
Answer: It is true that pool chlorine is stronger than bleach. For bleach and water to be the same strength as pool chlorine and water, you would have to adjust the ratio, increasing the bleach and reducing the water. But no matter which chlorine you use, make sure to test a small area before doing the job.
Many of us want to cool off in a backyard pool, but we also want to make sure there are no dangerous bacteria lurking in these pools that do not have any filtration system in place. You can use Clorox® Regular Bleach2 to treat the water in a child's wading pool.
Of course, too much chlorine in pool water can be dangerous. Exposure to over-chlorination can provoke asthma, lung irritation, and potentially skin and eye irritation. As well as being potentially bad for you, it's bad for your pool.
White Vinegar
Mix a 50/50 solution of vinegar and water, dip a sponge or soft cloth into it, and scrub that residue away. It's OK if a little bit of it makes it into the pool water, but if you're concerned, test the water after using vinegar, and adjust any levels if necessary.
The short answer is (you may have guessed it): no. It's not the best idea to clean your pool with vodka. Michael Dean, Co-Founder at Pool Research, a site that provides expert advice on all things related to pools, spends a lot of time advising people on how to clean their pools.
Things You'll Need
Accidentally dropping detergent or a bar of soap in your pool can be disastrous as soap bubbles form and the pH of your pool gets thrown off balance. Before your pool can return to normal operating condition, the soap needs to be completely removed.
It would work, as the soap alters the surface tension. But as others have pointed out, you don't want to add soap to your pool. It'd be great if people didn't bring suntan lotions and oils into a pool. But that's what cleaning a pool is for.