Pour one cup of fresh baking soda down the drain, followed by one cup of white vinegar. Place a rubber stopper or other sink hole cover over the drain opening. Wait 15 minutes to allow the vinegar and baking soda to unclog your drain, Then take out the drain cover and run hot tap water down the drain to clear the clog.
Use Baking Soda and Vinegar Pour a cup of baking soda into the clogged sink and wait for about four minutes. Afterwards, pour a cup of vinegar down the same sink. Plug the sink and leave it for 10 minutes to break down the blockage. Afterwards, run hot water to see if the clog is gone.
Add a half cup of vinegar and put something over the drain. Wait half an hour and then pour boiling water into the drain. Dish detergent: For a clogged toilet, pour a quarter cup of dish detergent into the bowl and then pour hot water over it. Use a plunger.
For DIY drain cleaning, you can use a mixture of baking soda and vinegar, followed by hot water, to clear minor clogs. A plunger can help dislodge blockages in sinks and toilets. For tougher clogs, a drain snake or auger can be effective.
Vinegar is effective at cutting grease and baking soda causes a reaction with vinegar that bubbles up and helps to remove blockages in the pipe. Pour the baking soda into the drain first, followed by a generous glug of white vinegar. Wait a few minutes until the mixture has stopped fizzing and flush with hot water.
Baking soda is abrasive, which, when used in large quantities, will cause the drain more damage. Additionally, the acidic nature of vinegar can eat away rubber and metal, damaging the plumbing. As these products break down the pipe and connectors in the plumbing in your home, it will cause more clogs over time.
Yes, hydrogen peroxide is safe to use for unclogging a drain. It will dissolve and loosen natural matter—like skin cells—stuck in the pipes. Hydrogen peroxide also reduces germs and disinfects the drain, helping it smell fresher and clean.
If your sink doesn't have a garbage disposal, use Drano® Kitchen Granules Clog Remover. It creates heat inside your drain to melt and dislodge greasy clogs.
Salt, Borax, and Vinegar
Start with 1/4 cup of salt, 1/4 cup of Borax, and then a 1/2 cup of vinegar. Add a pot of boiling water and let it sit for at least an hour or until it clears. Finally, rinse with hot tap water to clear all ingredients down the drain.
Hydrochloric Acid (Muriatic Acid)
Properties and Uses: Hydrochloric acid, also known as muriatic acid, is a highly corrosive acid used extensively by plumbers to clear severe clogs. It reacts rapidly with organic materials in drains, breaking them down into simpler compounds that can be easily flushed away.
Cola might be somewhat effective under these conditions: Your drain is really, really clogged: Cola needs a long time to work, so the cola has to be able to penetrate the clog for long periods of time. If your drain is only partially clogged, the soda will just pass through the pipe without any effect.
Although you can use 1/5 to 3/4 of a cup of bleach to clean and deodorize drains, followed by a good flushing of hot water, it will not clear a clog. Bleach is amazing at sanitizing and killing germs, but it won't eat through hair and soap scum that's trapped in the pipes and causing a clog.
Salt, Borax, and Vinegar
This potent mix is great for tougher clogs. Combine 1/4 cup of salt, 1/4 cup of Borax, and 1/2 cup of vinegar. Pour the gritty solution down the drain, followed by a pot of boiling water. Allow it to work overnight, if possible, before flushing with more hot water.
All you need to do is simply bring a pot of water to a boil, and then slowly pour it down the drain once it has reached a rolling boil. You may have to repeat this a few times to fully clear the drain clog. Boiling water won't hurt your pipes in the bathroom sink, and you can repeat this method as many times as needed.
If you put too much baking soda down a drain onto a clog, it can sit on the clog and become a solid mass as it is subjected to more and more water. This will make the block worse and even harder to remove.
The Santeen Sulfuric Acid Drain Opener proved to be the most potent among all the chemical drain cleaners we tested, effectively dissolving 80% of the hair, 80% of the organic matter, 40% of the grease and 76% of the paper products.
Drano's Max Gel Liquid Clog Remover works quickly too, without any elbow grease on your part. Simply pour the formula down a backed-up sink or drain and let it go to work. For minor clogs and slow-flowing drains, the gel works in 15 to 30 minutes.
Some of the best Drano alternatives include using a plunger or pipe snake, soap or salt mixed with boiling water, or baking soda and white vinegar. Also, for maximum effectiveness, you can combine several of these methods together to get rid of the clog.
It's definitely not strong enough to tackle serious food particles and microbial growth in a kitchen drain, though. While you can have better luck with a combination of baking soda and vinegar, it's best to use Dran-O, available at Target, or another chemical drain cleaner if your drain is clogged.
All you have to do is pour 1 cup or baking soda down your drain and then follow it with 1 cup of vinegar. After your mixture is in the drain, seal the top of the drain and wait for about an hour so your concoction can start breaking down any clogs. After about an hour, rinse your drain a few times with boiling water.
Mixing hydrogen peroxide and baking soda causes a chemical reaction that produces carbon dioxide and certain other chemicals which can cut through soap scum and hard water stains. This mixture can, therefore, be used to clean anything from bathroom tiles to cooking utensils.