Mix one cup of baking soda and vinegar, each near the source of the toilet clog and allow the reaction to take place. The bubbles created by the response will break down the clog. Give the baking soda mixture about 30 minutes to do its job, then follow it up with boiling water.
Pour several squirts of dishwashing detergent down your toilet, and follow it up with some hot water. Wait for around 30 minutes to give the soap time to work, and then, flush your toilet. If the clog is severe, you can allow the dish soap to sit overnight before flushing the toilet.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
One of the strongest substances for unclogging a toilet is a commercial drain cleaner specifically designed for toilet clogs. These cleaners typically contain powerful chemicals that dissolve organic matter and stubborn blockages.
Use Baking Soda and Vinegar: Pour one cup of baking soda and two cups of vinegar into the toilet. Let the mixture sit for about 30 minutes to allow the fizzing action to break up the clog. Then, try flushing with hot water.
Put soda and vinegar into the toilet: Take one cup of white vinegar, which you may have in your pantry, and an equal amount of baking soda – then pour it into the bowl. Put the baking soda in first for a better reaction. You can use smaller amounts for minor blockages.
Letting a clogged toilet sit too long can result in more severe problems. Beyond the risk of overflow and water damage, the clog could also cause toilet water to back up into other parts of your plumbing system, affecting sinks, showers, and even your home's main sewer line.
Dish soap is preferred, but if you can't break free to the kitchen, liquid hand soap, body wash, or a bath bomb can work. Squeeze about a quarter cup (or as much as you can) as close to the hole as possible. Add some hot (not boiling) water and let sit to help lubricate and loosen the clog.
Pour in boiling water.
The high heat will help soften compacted paper and flush small pieces away. Repeat using smaller amounts of boiling water if needed. Do not lean over the toilet during this.
Yes, a toilet can unclog itself over time, but it depends on what is causing the blockage. If the clog is made up of water-soluble materials, like toilet paper or fecal matter, then eventually they will begin dissolving if you give them enough time.
Epsom Salt. Epsom salt isn't just for bath time—it's also a surprisingly effective method for breaking down toilet paper clogs. To use this method, begin by pouring one to two cups of Epsom salt into the toilet bowl. Add hot water from the tap to help dissolve the salt.
The most common way to unclog a toilet without a plunger is by using hot but not boiling water. Heat up enough water to fill the bowl about halfway, then pour it into the toilet slowly and steadily. Let it sit in there for a while, and then repeat the process until you feel the water has started to drain.
Break Up the Clog With Hot Water or Drain Cleaner
Pour the hot water into your toilet and let it remain there for a few minutes to see if it loosens your blockage. You'll know the hot water is working if you see the water begin to recede. After that, give your toilet a couple of flushes to further break apart the clog.
Baking Soda And Vinegar
Instead of creating a volcano, this vinegar and baking soda mixture will work together to loosen up the clog in almost no time. We suggest wearing rubber gloves for this. As this method creates a pretty chemical reaction, it is recommended that you use it in a toilet bowl that is not too full.
You need water, not air, pressure to loosen the clog. If your toilet lacks water, pour in enough water till the plunger is covered. Use a gentle plunge initially since a hard one will force air back around the seal, blowing water all over you and your bathroom floor.
A very good method of unclogging a toilet without the need for a plunger is to use dishwashing liquid, especially if the obstruction is only partially blocked or results from grease or organic waste.
Additionally, letting a clogged toilet sit for a long time makes it more likely that more buildup, debris, and waste will accumulate around the blockage. That also leads to more serious clogs stubborn enough to require professional plumbing services.
Pouring dish soap down a toilet will unclog many obstructions. Pour 1/2- to 1-cup of dish soap directly in the toilet water and wait about 30 minutes before flushing. Follow the dish soap with a gallon of hot water if dish soap alone does not work.
METHOD #4: DIY DRAIN CLEANER
If you'd rather make your own drain cleaning solution, pour a cup of baking soda and two cups of vinegar into your toilet bowl, followed by plenty of hot (but not boiling) water. Allow the solution to work its magic overnight, then flush.
Bleach can often clear a toilet clog by breaking down the clog-causing materials. These include toilet paper, waste, and other debris. Pouring bleach into the toilet bowl and letting it sit can dissolve the blockage, improving water flow. But, bleach might not work for very tough clogs.