Household bleach, Clorox and liquid chlorine can all be used to sanitize a pool. They are all types of chlorine. Household bleaches such as Clorox usually contain about 5-6% available chlorine, about half that of pool liquid chlorine.
The solution to maintaining a clear pool is to use readily available liquid bleach as your chlorine source. Chlorine bleach, as discussed above, is not bound to a stabilizer, so when you add chlorine bleach to the pool, it will go right to work killing microbes and sanitizing.
Clorox itself recommends using between 100 and 200 ounces of regular-strength bleach per 10,000 gallons of pool water -- one gallon is 128 ounces, and many bottles of bleach are available in one-gallon or half-gallon sizes. Pool professionals tend to recommend more conservative amounts of bleach.
It is a good idea to wait at least 20 minutes after adding the water balancing chemicals. If you use calcium chloride in your pool, you should wait at least 2 hours to swim.
Best time is either after sunset, or when you need it. Bleach doesn't lose concentration overnight unless it has something to work on. In fact, a good way to tell if your pool is in good shape is to do an overnight chlorine test. Ideally, the FC at night should be the same as the FC level the next morning.
Of course, too much chlorine in pool water can be dangerous. Exposure to over-chlorination can provoke asthma, lung irritation, and potentially skin and eye irritation. As well as being potentially bad for you, it's bad for your pool.
High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria.
The main difference between bleach and chlorine is their strength. Chlorine is much stronger than bleach. To get your pools chlorine level to the point it needs to be to keep the pool looking clean and bright; you will need to use more bleach than you will chlorine.
Chlorine is a natural element and an ingredient of bleach, while bleach is a solution and the product of combining chlorine and other chemicals. 2. Chlorine exists in nature, while bleach is a manufactured product.
Bleach Versus Pool Chlorine
In addition to the chlorine itself, calcium and other inert ingredients make up the remainder of the chemical. Household bleach is a liquid that contains sodium hypochlorite, which is simply chlorine in its liquid form. Bleach, however, is typically only 5 to 6 percent chlorine.
Answer: It is true that pool chlorine is stronger than bleach. For bleach and water to be the same strength as pool chlorine and water, you would have to adjust the ratio, increasing the bleach and reducing the water. But no matter which chlorine you use, make sure to test a small area before doing the job.
Clorox is considered to be the most common bleach product that is used for pools. It has a 5.7% concentration, so if you have a 5,000-gallon pool, you will be using 3 cups or 24 oz to raise the chlorine levels.
Common unscented household bleach (sodium hypochlorite) works well to shock a pool.
There are alternatives to chlorine including bromine, ionizers, and ozonators, though with each you'll still need to use some chlorine. A fourth alternative is PHMB, which doesn't require the use of any chlorine. All four have drawbacks, including cost.
If your chlorine test turns orange, your pool water has a very high chlorine content, above 4 ppm. Stop using chlorine until the chlorine test shows a result within the normal range. If you want faster results, use a chlorine neutralizer to bring chlorine back into the proper range.
If you need to mildly shock a 30,000-gallon pool by raising the free chlorine concentration to 5 ppm, you need 2.5 gallons of bleach. To raise it to 10 ppm, you need 5 gallons.
Baking soda, also known as sodium bicarbonate is naturally alkaline, with a pH of 8. When you add baking soda to your pool water, you will raise both the pH and the alkalinity, improving stability and clarity.
At a 12.5% concentrate, liquid pool shock is approximately 2x's stronger than Clorox bleach. The recommends 5 tablespoons of regular bleach per gallon of water to properly disinfect a surface. When using liquid pool shock, dilute it at a rate of 2.5 to 3 tablespoons per gallon of water.
Most floating chlorinators can hold anywhere from two to eight weeks worth of chlorine, depending on conditions such as the season and your pool's size. An automatic feeder works in a similar way, allowing it to mix with the pool water slowly and deliberately. This type generally comes in a large bucket.
Household bleach, Clorox and liquid chlorine can all be used to sanitize a pool. They are all types of chlorine. Household bleaches such as Clorox usually contain about 5-6% available chlorine, about half that of pool liquid chlorine. Household bleaches often have unwanted fragrances and colors.
When bleach and water are mixed together to create a cleaning or disinfecting solution, the solution is only good for 24 hours. The temperature of the water does not affect the cleaning or disinfecting abilities of the solution. After the 24 hours, the solution begins to lose needed disinfecting properties.
Benzoni says any cleaner should be allowed to dry completely before applying a bleach solution. This will help to minimize the chance for exposure to a potentially toxic reaction.
If you put bleach in water, it will kill bacteria and tend to lessen anything that might be coloring the water. That's why chlorinated water is so common in municipal water systems and swimming pools. Tap water might have a chlorine concentration of 1 part per million (anywhere from 0.2 ppm to 4 ppm is legal).
Household bleach (5.25% sodium hypochlorite) mixed with water, is an inexpensive and effective disinfectant. By mixing different amounts of bleach with water, you can make a high, intermediate, or low-level disinfectant.
Well-known member. No! Splashless contains a type of soap as a thickener, and it will make bubbles in your pool, as well as HE washing machines. Don't use splashless bleach.