If the display shows 'CL' or a lock icon, you can disable Child Lock in the same way it was enabled. To do this, press and hold the buttons marked with a lock icon or labeled [*Child Lock] for at least 3 seconds.
Go to Start / Settings / Control Panel / Accessibility Options /Keyboard Options. b. Turn off CTRL lock if it's on.
The most common reasons your Whirlpool washer control lock won't turn off are a defective control panel, malfunctioning electronic control board, or a failed door switch.
Reset the washer: This can be done by switching it off and unplugging it for a couple of minutes. This may cause the door to automatically release. Disable the child lock: If the child lock is engaged, it will prevent the door from unlocking. Disable the child lock by holding the button for two to three seconds.
➔ To unlock CL on the washer, hold the Spin button on the washer control panel for 3 seconds. This guide was created for all models, so the images or content may be different from your product. Please fill out the required field. Please fill out the required field.
The most common cause is water left in the machine. Try running a spin/drain cycle. If this fails, the machine can be drained by placing the washing machine drain hose lower than the drum (into a bucket or tray). The door interlock has simply jammed.
A: If your washing machine is showing a lock symbol, it likely means that the safety lock feature is activated.
Washer Control Reset
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
On a Front Load Washer or the UltraFast Combo Washer/Dryer, press and hold either the Control Lock or Light-Control Lock pad for 3 seconds to lock or unlock the controls. Some older Front Load Washer models simply had a Lock button. You press and hold the Lock button for 3 seconds to use the feature.
To remove a lock washer, use a wrench or a similar tool to remove the nut or threaded fastener that holds the lock washer in place. Next, use a flathead screwdriver to pry the lock washer loose. If you remove a split washer, place the screwdriver head under the washer or inside the split.
Normally waiting for the cycle to end is all you need to do to unlock the door, or turn your washer on if it's off. If you get stuck, though, you can drain the water from front load washers using the emergency drain hose; once the water is gone, the door will unlock.
Press and hold the start button for three to five seconds
To deactivate the child lock, press and hold the start button for three to five seconds. After this time you will hear an audible beep and the key symbol will disappear.
To deactivate the control lock feature, hold down the designated control lock button for your device for three seconds.