Shock is liquid or granular chlorine. You should add one gallon (or one pound) of shock per 10,000 gallons of pool water every week to two weeks. During hot weather or frequent use, you may need to shock more frequently.
Daily as needed and indicated by measurement. One caveat, however: if your total alkalinity and pH are not where they should be, you will find it difficult to keep enough free chlorine in your pool water. Adjust your alkalinity first, then correct your chlorine.
Most floating chlorinators can hold anywhere from two to eight weeks worth of chlorine, depending on conditions such as the season and your pool's size. An automatic feeder works in a similar way, allowing it to mix with the pool water slowly and deliberately.
We suggest shocking the pool every week to two weeks; with hot weather or increased use, you may need to shock more often. When tabs run out, replace them.
Liquid Chlorine has the shortest shelf life of all your pool chemicals, losing up to 50% or half of its potency six months from when it was first opened and up to 90% after a year.
A chlorine level of between 3-5mg/l must be maintained in your hot tub at all times. The addition of chlorine will depend upon usage and bathing habits. It could be daily or every 2-3 days (for 1mg/l add 2g per 1000 litres).
How Often Should I Shock My Pool? Shocking your pool regularly will help to keep the water clean and free of contaminants. You should aim to shock your pool about once a week, with the additional shock after heavy use. Some tell-tale signs that your pool needs to be shocked are cloudy, foamy, green, or odourous water.
On average, you should check your chlorine levels at least two to three times a week. However, for new pool owners, you may want to begin by checking your chlorine levels once a day. This daily routine gives pool owners time to learn their pool in relation to their swimming habits and weather.
Annual booster additions of pool salt are usually required, but only to replace salt lost from backwashing, splashout or lowering the water for winter. If you fully drain the pool for maintenance, you will need to replace all of the pool salt.
We recommend that our customers run their pumps rain or shine UNLESS we have an electrical storm. In that case, lightning could strike an outside circuit, which could damage your pump and other equipment. If you're worried about lightening, turn the pump off or shut off the breaker.
NEVER just throw them into your pool water. This will cause them to dissolve on the floor and it can damage and create a permanent bleach stain to your liner or concrete.
Shocking your pool isn't necessary, although, it's not a bad idea either. If you get an extremely heavy rain fall, you could shock your pool for good measure. This will help fight off any contaminants that the rain may have brought to your pool.
When do you add chlorine? You should put chlorine in your hot tub at least once a week. However, some people prefer to add a small amount after each use. Finding the best water care routine will depend on how often and how many people use it.
To properly maintain the water chemistry in your swimming pool, put chlorine tablets in a floating chlorine feeder, and once a week, add 3 lbs of shock to the pool at night. The next morning, add algaecide to the pool. Use test strips twice a week to monitor the levels of the chemicals.
For pool startup, it's best to double shock your pool, meaning that you add two pounds of chlorine shock for every 10,000 gallons of water. After shocking a pool, aim to have chlorine at 10 ppm. After this routine, your pool should be good to go.
Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time. Residential pool water only needs to be turned over once daily to have proper filtration.
Remember, rain is acidic. Hence, pool overflowing from rain causes the Alkalinity and pH levels to lower. Very low pH causes pool water to turn very clear and acidic, which destroys your pool surface and equipment.
It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.
Chlorine tablets are slow dissolving and therefore need to be placed in either a floating dispenser, in-line chlorine feeder or a skimmer basket.
For the greatest protection against algae, bacteria, and cloudy water, Intex pools should maintain a chlorine level of 2.0-4.0 ppm at all times. If you opted for the Intex Salt Chlorinator, you can make your own chlorine by adding the correct amount of Pool Salt to the water.
Even if you're not using your pool in the winter, you should still be running the pumps every day to keep your pool clean and prevent algae build-up that can be difficult to remove. Pool pumps have two major functions: filtering dirt and debris and producing chlorine.
Give your pool a good shock treatment 1 to 2 days before the storm hits. You can bring the chlorine level up pretty high to prolong the pool being depleted of chlorine.
A typical swimming pool pump used on sand filter systems consumes between 750 and 1100 watts of power (or 0.75 kW and 1.1 kW). A light bulb consumes between 0.06 and 0.1 kW).