Wet clean: Plan to mop the tile floor in your kitchen once every two weeks and your bathroom tile floor once a week (germs tend to build up in bathrooms). Take the time to spot clean your grout once every few months or whenever it's looking dingy.
Any high-traffic areas in your home should be wet mopped once a week. Rooms in your home that are not frequently used—such as a guest room—do not need to be mopped weekly. Mopping every other week or monthly should be sufficient.
One to two weeks.
Give floors a good wash or steam once every couple of weeks, says Tetro. You might want to wash your kitchen floors a little more often, due to food bacteria that can spread around.
Too Much Floor Cleaning Product: It's a common misconception that using more than the recommended amount for cleaning products yields cleaner floors, so be careful not to use too much. Too much product can leave a leftover residue that is more difficult to clean.
Sweep or vacuum your tile floors a couple of times a week. Sand and grit can dull and scratch the surface. Once you've removed the dirt, you're ready to mop. Mix a mild detergent with hot water and apply with a rag or chamois mop instead of a sponge mop.
Swiffer's WetJet cleaning system is brand-specific, so you're committed to using its cleaning formulas and mop pads. However, it's safe for use on any sealed tile and leaves no residue behind. It's a best-selling floor cleaner for a reason and might be the easiest option for an all-in-one tile floor cleaner.
A common concern about mopping is its effectiveness. A dirty mop will just move the filth around the house and not clean the floors. However, a clean mop and good mopping technique will effectively remove grime and germs from the floor.
Sticky floors occur when you leave behind too much cleaning solution, use the wrong floor cleaner, or not rinsing with clean water after mopping. You can clean the residue off tile and wood floors and then rinse using a clean mop and water. Clean with a steam mop to remove the sticky residue easily.
Floors remain dirty after mopping for many reasons. If the mop is not rinsed, the dirt remains stuck on it. The overflow of water during cleaning leaves a slurry layer of dirt on the floor. Not vacuuming the floor before mopping is also a major reason for dirty floors after mopping.
In this case, we recommend giving your floors sweep and mop sessions once a week. Dust and dirt can accumulate over time if no one is going in and out of different rooms. Use a day off or the weekend to sweep floors so that your floors don't absorb this material and lose its prime condition.
"We recommend dusting a home at least once per month for easy-to-reach areas and every three to six months for hard-to-reach areas such as ceilings, corners, door frames, and high shelves," says Jennifer Rodriguez, director of business development at Pro Housekeepers.
The first time, wet the entire floor (don't flood it, just get it good and wet). This will loosen the dirt and any sticky goo. Mop around the edges first, then move to the middle of the floor, using overlapping, figure-eight strokes. When one side of the mop gets dirty, turn the mop over to the clean side.
Fill a bucket with hot water, a half cup of vinegar and a half tablespoon of dish soap. Don't use too much soap, or the soapy residue will make your floors look dull. Before you mop, rinse out the mop head under hot running water to remove any debris from last time you used it. Mop the tile floors with soapy water.
To do so, mix 1 gallon of hot water and 1 cup of white vinegar in a bucket. Use a soft mop that won't scratch your floors, and always vacuum before you mop to remove debris. Never use red wine vinegar or balsamic vinegar; though, in a pinch, apple cider vinegar may be used.
1. Sweep often — at least once a week. By sticking to this routine, you can clean your floors before dirt has time to collect on the surface.
Ultimately, traditional mops are still the best option for deep cleaning. You can put more pressure on the head, and you can use any cleaning solution (rather than the Swiffer-only options) and as much of it as you need.
When the cleaning solution becomes visibly dirty, it's time to change rinse out the buckets, change the mop head and start with fresh cleaning solution. There's no standard regulation concerning the frequency with which mop heads or water should be changed.
Cotton string mops are full of germs.
The dense microfiber blend promotes deeper penetration for cleaner surfaces. Compared to a traditional mop head, microfiber mops can reduce bacteria by 96 percent.
Tile Floors Products
Just choose your favorite. All of them will leave your home smelling fresh and clean. You can also use Pine-Sol® Original Squirt 'N Mop®. It's safe for wood and hard nonporous surfaces like ceramic and porcelain tiles, and also sealed granite.
Bona's mop distributes cleaning solution more evenly than the Swiffer WetJet. Bona's mop head is significantly wider (15 inches) than Swiffer's (9 inches), which makes it easier to clean large rooms but more difficult to navigate in small spaces. Bona's spray mop comes with a reusable microfiber mop pad.
Mild dish soap is a surprisingly good floor cleaner. All you need is 1 to 2 tablespoons of dish soap mixed in with a bucket of water. Floors will be clean and shiny in no time. Dish soap is very effective on resilient floorings, such as linoleum and vinyl, and also works well on ceramic tile.
Keeping your mop impeccably clean is essential, since even a little bit of leftover soil can result in a sour smell or breed bacteria. To keep yours in good shape, rinse the mophead thoroughly in a bucket of clean, hot (but not boiling) water immediately after mopping.
Usually no rinsing required. On wood surfaces, do not allow puddles of cleaner to remain. *Not recommended for use on unfinished, unsealed, unpainted, waxed, oiled or worn flooring.