How Often Should I Shock My Pool? Shocking your pool regularly will help to keep the water clean and free of contaminants. You should aim to shock your pool about once a week, with the additional shock after heavy use. Some tell-tale signs that your pool needs to be shocked are cloudy, foamy, green, or odourous water.
You cannot overshock a swimming pool or add too much. Adding too much shock or overshocking your pool will kill off algae. The negative of adding too much shock is it will upset the chemical balance of your pool.
So if you buy liquid shock, be aware that it only lasts one to two months at the most before it starts to lose effectiveness. While many swimming pool chemicals stay good for years if stored correctly, some pool-maintenance supplies expire more quickly.
It's often recommended to shock your pool once a week. If you don't do it every week, you should at least do it every other week. This is necessary to maintain your pool's water chemistry. If you have a lot of people over in your pool or have a party, you may want to shock your pool more frequently.
After Shocking Your Pool
It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours. It is always best to test first!
It's pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn't be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.
How Often Should I Shock My Pool? Shocking your pool regularly will help to keep the water clean and free of contaminants. You should aim to shock your pool about once a week, with the additional shock after heavy use. Some tell-tale signs that your pool needs to be shocked are cloudy, foamy, green, or odourous water.
Chlorine is a sanitizer, and (unless you use Baquacil products) is necessary for maintaining a clear and healthy pool. Shock is chlorine, in a high dose, meant to shock your pool and raise the chlorine level quickly.
This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.
Liquid chlorine and granular shock have the same active chemical that sanitizes your pool, what changes is the strength and the way you use it. Liquid chlorine is less costly, unstabilized and comes in liquid form. Granular shock is stabilized and comes in a solid form that dissolves in your pool.
Neither will chlorination be effective with a diffuser and without a pump. The best thing to do is to apply liquid chlorine in the pool. Then, you have to circulate the pool manually with the use of a telescopic pole or paddle. This will ensure the chlorine disperse well.
So, not only is shocking a saltwater pool okay, but it's actually important to your pool's health. Shocking is the process in which you overload your pool with chlorine (3-5 times the normal amount) to improve your pool's cleanliness and kill off organic matter.
Shocking your pool isn't necessary, although, it's not a bad idea either. If you get an extremely heavy rain fall, you could shock your pool for good measure. This will help fight off any contaminants that the rain may have brought to your pool.
Daily as needed and indicated by measurement. One caveat, however: if your total alkalinity and pH are not where they should be, you will find it difficult to keep enough free chlorine in your pool water. Adjust your alkalinity first, then correct your chlorine.
High doses of chlorine, like pool shock, can cause temporary cloudiness as it kills contaminants. High levels of pH, alkalinity, and calcium hardness are more likely to cause cloudy water.
Cloudy water may still be safe to swim in, but if the chemicals are not balanced, then swimmers can experience red eyes, irritated skin, and rashes. If the cause is environmental factors, it can usually be cleared up with a clarifier and regular cleaning.
Adding chlorine besides the shock can increase the chlorine content in the water which can make the entire shocking process useless. Hence, it is better if you don't use the shock and chlorine at the same time. The best time to add chlorine to the pool water is after you have shocked the pool.
Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time. Residential pool water only needs to be turned over once daily to have proper filtration.
It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.
The Department of Environmental Health recommends avoiding activities such as swimming, surfing, and diving for 72 hours after it rains. Research has shown that the risk of infection is the highest during and the day after rain, and declines to around normal levels after three days.
While green algae are endemic in salt water pools, they are the easiest to kill. Green algae tend to grow during summers when the temperatures can get high. They float freely in the pool, making the water green. You might even see them growing on the bottom of the pool, on the walls, or in the crevices.
As shocking has a tendency to push metals out of solution and salt (even when labeled as pure) can contain trace amounts of metals, it is recommended that you add salt at a different time from shocking.
The best thing about this dry liquid chlorine formula is that it dissolves very rapidly, even in cold water temperatures. We've packaged it in an easy to pour bottle, just walk it around the pool – no need to pre-dissolve.
Run the pump for 8 hours, every 24 hours. You can also pause in between; there is no need to run it continuously. Ideally, after you shock the pool, be sure to run the pump at night and during non-peak hours, to save on your energy bills.