Kwikset locks operate by matching the cuts on the keys with the bottom pin tumblers inside the cylinder plug. There are two sets of five pins in each lock, top and bottom, and a set of springs.
Many locks are made of the same basic parts: pins (usually 12) and springs. The upper six pins are the same size, and the bottom six pins come in varying sizes to match up with the grooves on your particular key.
As you can see in the picture below, Schlage uses 4 security pins (called “Spool pins), while Kwikset uses only 2. Having 2 more security pins in a cylinder can make it significantly harder to pick, which can definitely be felt when trying to pick a Schlage lock.
each pin in a Kwikset has six depths, the first pin can have six depths, the second pin six depths, etc, so it is 6 to the power of 5 or 7776 theoretical unique keys.
It will be between 4-8 digits. The programming code cannot be the same as any user code. 6) Press Kwikset button. 7) Re-enter programming code.
Total Key Control
Thanks to the two-cylinder Key Control Deadbolt with SmartKey Security, you can have one master key for all your units and unique keys for all of your tenants.
...the lock itself is so weak that a 10 year old kid can slam a screwdriver in it and force the cylinder to turn and unlock and be in your house in a matter of seconds... Any thief with a "bump" key will open this 200+ dollar lock in 5 seconds... Kwikset locks can be easily unlocked with a blank and a screwdriver.
From looking at the key the valleys of the cuts will tell you how many pins the locks has. I just google imaged those, I no nothing of that site. You can also place a pick in a lock, lift up on all pins, and draw the pick slowly towards you. Count the number of pins you hear resetting.
Insert a shallow pick into key way, all the way to the rear of lock. Using the tip of the pick gently lift up and slowly drag pick forward. Count each click you hear until pick comes out. Each click is a pin dropping!
The Master Lock 9140EURD has the following specifications: 40mm aluminium padlock - 21mm hardened steel shackle, 6mm diameter - 4-pins.
Can I replace my 5 pin euro lock with a 6 pin? Yes and they can be any make too. 5 pin locks are found on a lot of the older euro cylinders but these are now made as 6 pin. The extra pin means the key is slightly longer and that's all it is.
The most common security pins you'll run across are “spools” given that name because they resemble a thread spool. There's a variation of the spool called a “mushroom” because its shaped like a mushroom.
A 6+2-pin connector is, for all intents and purposes, an 8-pin one — it's just divided into two parts, so you could also use it as a 6-pin power cable if need be.
Because Schlage locks are made of stronger materials, are superior in their mechanism, and provide far greater security than Kwikset locks, it should be mentioned that they are more expensive compared to Kwikset.
Check that the bolt hole is at least 1” deep so the bolt fully extends. Check that the door closes properly so that when the deadbolt is extended, it is going into the bolt hole and not hitting the deadbolt strike or door frame. Check that the mounting screws securing the exterior keypad are not over-tightened.
Perform a factory reset. This procedure will delete all User Codes associated with the lock, and the default Programming Code (0-0-0-0) and User Code (1-2-3-4) will be restored. 1. Make sure the door is open and unlocked. Press and hold the Reset button for 5 seconds, until you hear 3 long beeps. 2.
Bump keys are keys cut to a special design that will allow them to be used for picking pin-tumbler locks. Pin-tumbler locks are the world's most popular lock, and these include exterior door entry locks for homes. The process of gaining entry using a bump key is called “bumping,” and it can be very effective.
KWIKSET'S NEW SC1 KEYWAY BRINGS SMARTKEY SECURITY, MORE KEYING OPTIONS TO USERS AND PROS. LAKE FOREST, CA (November 2, 2020) – Kwikset, the leading residential lock manufacturer, introduces the SC1 Keyway, featuring Kwikset's exclusive SmartKey Security Technology.
Learning how to pick a lock with a hairpin can be a fun challenge, but sadly it doesn't always work. Bobby pins are bulky, and some locks have slimmer keyways that are too small for a bobby pin to enter. So if you really want to learn lockpicking, I would highly suggest considering a basic lock picking set.
The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.