After adding pool salt to your swimming pool, it is always recommended to wait for at least 20 to 45 minutes so that you can swim in the pool.
It's recommended to wait at least 20 minutes to swim after adding salt to your pool. If you're adding calcium chloride to your pool water, it's recommended to wait two to four hours before swimming again.
Use a brush to help the salt dissolve and to prevent the salt from piling up on the bottom of your pool. Run your pump for 24 hours to help distribute the salt evenly throughout your pool.
Brush the salt towards the main drain. The salt should be dissolved within 24 hours. After the salt has dissolved, the salt chlorine generator can be started.
As shocking has a tendency to push metals out of solution and salt (even when labeled as pure) can contain trace amounts of metals, it is recommended that you add salt at a different time from shocking.
A low salt level will reduce the efficiency of your salt chlorinator and result in low chlorine production. A high salt level can cause your chlorinator to shutdown and may begin to give your water a salty taste.
But essentially you do just pour salt into the pool, a lot of salt. How much salt to add to the pool? To reach the initial salt level recommended by the salt system manufacturer (usually 2400-3200 ppm), you will need to add about 200 lbs of pure pool grade salt (NaCl), per 10,000 gallons of water.
Undissolved Granules
The presence of these granules does not indicate that you have added too much stabilizer -- the product is slow to dissolve, particularly when static. You can speed the process by agitating the granules with a brush so that they circulate in the pool water.
Just like a chlorine-based pool, saltwater pools turn cloudy when chemicals are not balanced. You need to ensure that all chemicals are balanced all the time to avoid cloudy water and growth of algae. The major causes of cloudiness are chlorine, pH, Salinity, total alkalinity, cyanuric acid, and calcium hardness.
So, not only is shocking a saltwater pool okay, but it's actually important to your pool's health. Shocking is the process in which you overload your pool with chlorine (3-5 times the normal amount) to improve your pool's cleanliness and kill off organic matter.
Stabilizer is a chemical added to offset the harshness of chlorine. Because saltwater pools don't have the chemical chlorine, a stabilizer isn't required.
Wait until the shock process is complete, then put in the salt. It'll dissolve right away and be ready for the SWG by the time you get ready to use it.
Shock your pool once a week with Salinity Surge Shock or Salinity Oxidizing Shock. Pool shock works as an added defense against bacteria and contaminants. With Oxidizing shock, you can use your pool after just 15 minutes!
Sometimes a saltwater pool's chlorinator isn't creating enough chlorine, and the water can become cloudy or develop algae. When this happens, a bit of chlorine can save the day, said Hunker. You can add extra chlorine to the pool through calcium hypochlorite, sodium hypochlorite, or chlorine tablets.
Generally it's better to have the level on the high side than low, so 3800 should be fine.
The overall cost of salt for a saltwater pool will vary by the type of salt that you use and the size of your pool, but you can expect to pay on average between $10 and $25 per every 40 pounds of salt (or 25¢ to 63¢ per pound of salt). Some brands may even sell a 40-pound bag of pool salt for as much as $40.
Yes, a salt water pool has a reduced cost of operation as compared to a traditional chlorinated pool. This cost savings is primarily because chlorine is generated from salt and there is no need to buy chlorine. Additionally, salt water pools require fewer chemicals to keep the water clean and clear.