I use a squirt of Method dishwashing liquid, and I usually dump and refresh the water once. Squeeze out a little water on the floor. Don't hold me to the science of this one, but I find it helps to squeeze out a tiny puddle and then spread and scrub from there. It seems to work better than a barely-damp sponge.
Vacuum, dust or wipe with a lightly dampened mop – never use soap-based detergents, as they can leave a dull film on the floor, and avoid over-wetting. Don't use wax polish either, as this will make the floor slippery. To remove marks and stains, use a dilute solution of water and vinegar.
If it's not too dirty, you can just use dish soap and hot water. For your mopping solution, mild dish detergents are best – even just a few drops of dish soap and hot water will do for linoleum. Also, any combo of apple cider vinegar and water or even a baking soda scrub for tough stains is fine for linoleum.
Any high-traffic areas in your home should be wet mopped once a week. Rooms in your home that are not frequently used—such as a guest room—do not need to be mopped weekly. Mopping every other week or monthly should be sufficient.
Combine 1/2 cup water, 1/2 cup dishwashing detergent, 1-2/3 cups baking soda, and 2 tablespoons distilled white vinegar. Stir the mixture until everything is dissolved. Pour it into a spray bottle. Wash flooring in small sections by spraying on, mopping off, then rinsing thoroughly with warm water.
It is preferable to use cold water instead of hot water when mopping. The reason is that it does not damage the flooring and it retains floor shine. It also helps in eradicating germs and bacteria. Additionally, cold water saves a lot of electricity and leaves off a cooling effect later after cleaning.
Mix one gallon of hot water, one cup of vinegar, and a few drops of dish soap. Mop the floor with the solution, using the scrub brush to remove stubborn dirt, or in high-traffic areas. Once the entire floor has been cleaned, mop once more using clean water to remove any remaining traces of baking soda or soap residue.
It's actually fairly simple: Scrape it up. When you have a pile of flour on your countertop or floor, use a bench scraper, pastry scraper, spatula, an old credit card, or even a stiff piece of paper to scoop up the flour. Do it a few times to gather as much of the flour as you can.
You can choose either a brush, sponge or cloth. A brush is great for scrubbing off tougher stains, so even if you choose to do the majority of the cleaning using a sponge or cloth, it's good to keep a brush on hand. Microfiber cloths work well for cleaning floors, but most rags will work.
Swiffer WetJet is an all-in-one mopping system that's ready to use right out of the closet. Start with a fresh pad and spray the cleaning solution through the uniquely designed, dual nozzled WetJet mop. Then watch the dirt and grime dissolve while the thick pad absorbs it deep inside so it doesn't get pushed around.
'You could try a more modern alternative to the traditional mop head and bucket, such as the e-cloth Deep Clean Mop, says Lisa. You can put the dirty e-cloth into your washing machine and wash at above 60C to kill bacteria, and dry. '
What can happen if flour is not stored correctly? If moisture is allowed to get into the flour, it may cause it to become clumpy. In some cases, flour can attract psocids (see below).
Flour. If you accidentally spill flour all over the floor, your first impulse might be to bust out the vacuum. But fine powders and dusts can actually clog your vacuum.
Moisten the remaining flour with a good amount of hot water. The water will begin to make the flour “gooey” again so it is easier to remove. Allow the water to set on the flour for a couple of minutes so that it can thoroughly saturate it again. Next, use the scraper to scrape the moistened flour away.
Soap only lifts dirt and oil into water, making them suspend in water. Therefore, the more soap you use, the more your mop gets saturated with dirt. So, if you do not remove all the soapy water from the floor, the dirt remains, forming streaks on the floor.
This is because some floor cleaners include chemicals and additives, and these can put a lot of residue onto the floor. The more you use the cleaner, the more layers of the residue will build up onto the floor. This can make your floor lose some of it's shine, and it'll just look perpetually dirty.
Mix ½ cup of vinegar with one gallon of hot water to create your mopping solution. Wring out your mop thoroughly so that it is only damp and doesn't saturate wood floors with moisture to avoid damage.
Light dust and soils on a hard floor surface can very effectively be removed with water only. Heavier soils, sticky syrupy soils, petroleum based soils, kitchen areas and restrooms typically require more than water and there are specially designed chemicals for these.
Many people think you need to mop with boiling water to thoroughly clean your floors. This, however, is a myth – rather than always giving you a better clean, the temperature of the water can actually have a negative effect.
Combine ¼ cup white vinegar, ¼ cup baking soda, 1 tablespoon dish detergent, and 2 gallons hot water. Apply it either with a damp cloth or a wrung-out mop. After, go over it with fresh water, then allow to dry.
One to two weeks.
Give floors a good wash or steam once every couple of weeks, says Tetro. You might want to wash your kitchen floors a little more often, due to food bacteria that can spread around.
A plastic storage container with a tight lid is ideal, but a large Ziploc bag is totally fine, too. The impermeable container will keep out pests as well as moisture. Most people find it easiest to keep flour in the pantry. Avoid warm, sunny spots.