No, modern heat pumps do not stop working in extreme cold. While older models struggled below freezing, today’s advanced "cold-climate" systems extract usable heat from outside air even when temperatures drop to
When it's extremely cold outside, the temperature difference is large, which makes it harder for the heat pump to transfer heat effectively. As a result, the heat pump may have to work harder and use more energy to maintain a comfortable indoor temperature, which can reduce its overall efficiency.
Heat pumps don't necessarily "stop working" at specific temperatures, but their efficiency drops significantly as it gets colder.
If your heat pump isn't working, here's a quick list of steps to try before calling for help:
What's the 20-degree rule for operating heat pumps, and how do I apply it? This rule suggests you keep your thermostat setting within 20°F of the outdoor temperature. Don't set your heat pump to heat your home too high when it's very cold outside.
The reality is that it's usually not a good idea to simply keep a heat pump operating all through the night while you're asleep. Instead, you should make sure that you have a programmable thermostat and set it to have it lower the indoor temperatures by 8° to 10°F when people are asleep.
If your heat pump is unexpectedly expensive to run, the most common culprits are inefficient auxiliary/backup heat, high local electricity rates, or a system that isn't sized properly.
Most heat pumps should complete about two to three cycles per hour, with ten to twenty minutes of downtime between each cycle. If you notice your system cycling too frequently or not enough, it could indicate an underlying issue that needs attention.
It takes time for your home to warm up and cool down. If you're not sure how long it takes, try turning the heating on about 30 minutes before you need it. You should turn it off 30 minutes before you'll stop needing it.
Run the Heat Pump's Fan
If your heat pump isn't operating properly, even after you've given it 3-4 hours to automatically defrost itself, then you could try unfreezing the system by turning on the fan setting (provided yours has one). Running the fan can help you thaw the heating system within an hour.
No, You Should Not Turn off Your Heat Pump when It Gets Cold
When it's cold, they pull warm air into the house. Even on a cold day, the heat pump can draw some warmth out of the air, enabling it to generate three to four times the amount of heat as what would have been produced by the same amount of fuel consumed.
In outdoor temperatures above 30 degrees, the heat pump should cycle off and on like a normal furnace. Somewhere between 20 and 30 degrees outdoor temperature, the heat pump will reach a “balance point” where the heat needed by the home is equal to the heat supplied by the heat pump. So now it will run all the time.
In fact, research shows that cold-climate heat pumps can provide comfortable domestic heating when it is as cold as -15°F outside — and that's air temperature, not wind chill!
In general, today's most efficient traditional heat pumps can provide 100% heating capacity down to around 32°F and then may start losing heating efficiency. If cold-weather performance is important to you, look for a higher Heating Seasonal Performance Factor (HSPF2) rating.
Short answer: No. Switching your thermostat to emergency heat or “em heat” just because it's cold outside will just raise your energy bills like crazy. Don't use emergency heat mode unless your heat pump stops heating your home altogether. If that happens, contact a professional heat pump repairman for help.
Your heat pump will still work below freezing and below 15 degrees. It will continue to perform below 0 degrees or colder. It just won't be as efficient over those very coldest days of winter as using a gas-fired furnace.
Heating and energy expert Stephen Hankinson said that one "big energy cost saver" is to make sure you have your heating off when you're not at home. For instance, if you typically arrive home from work at around 6pm on weekdays, you could set your heating to activate just as you walk through the door.
Heating and cooling (HVAC) systems are the biggest energy consumers in a typical house, accounting for roughly 45−50% of your total electricity usage. Water heaters, refrigerators, and lighting round out the rest of the major draws.
A detailed study from the National Renewable Energy Laboratory found residents preferred a wintertime heater setting between 67 °F and 70 °F (19 °C to 21 °C). The Department of Energy recommends a winter heat setting of 68 °F (20 °C), which matches up very well with the temperatures most of us are comfortable with.
Typically, a properly sized furnace will run for about 10–15 minutes per cycle during colder months. If your furnace turns on every few minutes, it may be short cycling, which can indicate issues such as a clogged filter, blocked vents, or an oversized unit.
If your heat pump is unexpectedly expensive to run, the most common culprits are inefficient auxiliary/backup heat, high local electricity rates, or a system that isn't sized properly.
There are two entirely different HVAC concepts known as the "20-degree rule" for heat pumps. The first is a user guideline that suggests setting your thermostat no more than 20∘F above or below the outdoor temperature. The second is an equipment metric referring to the system's "temperature split" or output efficiency.
Your heating and cooling system is by far the biggest energy consumer in your home. Air conditioners, furnaces, and heat pump HVAC systems work hard to keep your home comfortable year-round, but they also account for almost half of your energy bill.
What are the disadvantages of a heat pump?
An overcharged heat pump means there is too much refrigerant in the system, which elevates operating pressures and stresses the mechanical components. Common symptoms include diminished heating and cooling output, unusually high electricity bills, frequent system shutdowns, and sweating or frosted-over lines near the compressor.