Attempting to force a clog through a toilet with a plunger can often make the problem worse. Instead, create a seal and slowly push down on the plunger before pulling it back sharply. The suction can help pull the clog back up toward the bowl, breaking the blockage and allowing gravity to take over.
Start slow and add force as needed. Several gentle pumps will usually work better than a couple of hard pushes. If your blockage is going to come out, it should happen in less than 10 minutes.
Don't use excessive force when plunging a clog. Also, keep in mind that you shouldn't use too much pressure because it can damage the drain line connection, which will lead to further problems eventually.
Ideally, no more than five or 10 minutes. One plumber told us that if plunging goes on any longer, it's time to try a toilet snake or call an expert.
So, let's recap the common reasons why a toilet won't unclog — excessive toilet paper use, non-flushable solids, hard water, and clogs in the main sewer line. Thankfully, they can be prevented via methods like double-flushing, covering the toilet bowl, routine inspections and dealing with tree roots.
Is it okay to leave a clogged toilet overnight? In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
However, if the clog is especially tough, your plunger may not be enough. So, what else can you do to clear a badly clogged toilet? The first thing you should do is stop flushing. If your toilet doesn't drain, persistent flushing will only fill the bowl with more water, making the problem worse.
Plunge Correctly
Give a few good up and down strokes with the plunger and flush the toilet. If the water clears from the toilet, then you've successfully unclogged it. If the toilet starts overflowing again, just close the flapper to stop water from entering the bowl.
Baking Soda And Hot Water
Pour about half of a cup of baking soda down the drain and then follow up with a pot of boiling water. Let it sit for an hour or two before you try flushing again. It might take several attempts, but this method has been known to work really well in unclogging slow draining toilets.
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores. Pour a ¾ gallon of cold water into a bucket, and add 3 cups of caustic soda.
Maintain a seal and plunge up and down rapidly, keeping the plunger under the water level and lifting it only an inch or so on every upstroke. Be patient, as it may take multiple plunge cycles, of a dozen plunges per cycle, to loosen the clog. Flush to see if the clog has cleared. If not, repeat.
Plunge-in well:
The plunging process needs to be down slowly; operating anything by force will ruin the bathroom with water. After the primary gentle plunge, forcing the air out they dig into plunging in and out strenuously, keeping the seal intact, for 15 to 20 times until most of the clogs are not unclogged.
When a toilet has a clog made of water-soluble materials, it has a chance of slowly dissolving in the water and freeing up the toilet to work properly again. So, clogs that are primarily made of toilet paper can clear themselves.
STEP 3: Inset your plunger into the toilet at a 45-degree angle, allowing water to enter the plunger head – this will prevent splashing and prevent water from overflowing when the toilet bowl is full. STEP 4: Tilt the plunger upright. This will allow the plunger to seal to the outlet hole.
Using too much toilet paper
This is probably the most common reason toilets get clogged — and often the easiest to deal with. If we're honest, most of us are probably guilty of this one. If you're one of the many people who use a lot of toilet paper when you use the bathroom, here are a few tips!
Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs. Be patient.
If you find yourself with a clogged toilet, you don't have to call the plumber immediately. The first thing you need to do is turn off the toilet's water supply. This will stop the toilet from overflowing.
A drain auger is a better choice, but the wire hanger will work in a pinch.
If water is rising in the bowl immediately after you've already flushed, that means a clog is blocking the water from moving through the toilet drain. If you flush again, there will be even more water that's unable to make it past the clog, and you'll end up with even more flooding from the toilet bowl.
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water.