“Fill up the sink with hot water & a cap full of your favorite Pine Sol floor cleaner. Add 2 tbsp of vinegar & use to clean any type of floor. I use this method on my hardwood floors to get a clean, smooth & shiny surface!”
Bottom line — mixing bleach with Pine-Sol produces chlorine gas that can be harmful or even toxic. Never do it.
To make your Pine Sol fly repellant mix ⅓ water, ⅓ vinegar, and ⅓ Original Scent Pine Sol. You can add a dash of Skin So Soft or Citronella to the mix if you like, too. Spray it on as needed. This mix works almost as well as Neem, but won't cause a pregnant horse to miscarry.
Mix a 1/2 cup pinesol with 2 cups of vinegar, & a 1/2 cup of water in a spray bottle. Spray surface with mixture. Spills immediately started to lift. I then sprinkle baking soda over the surface then a little dawn.
Common household white vinegar is an effective cleaning substitute for Pine-Sol. Vinegar is nontoxic and since it is acidic, also dissolves stains on hard surfaces. Also, priced at just a few dollars a gallon, vinegar is less expensive than Pine-Sol.
Q: Can you mix Pine-Sol® with other products (like glass cleaners, bleach, etc.)? A: We do not recommend mixing any Pine-Sol® product with other cleaning products or chemicals. Mixing cleaners can result in the release of hazardous gases.
In a microwavable safe glass container, mix ⅓ cup Dawn dish soap with 3 cups white vinegar. Microwave for five minutes until simmering. Spread the mixture in sink basins, bathtubs and showers.
Just like vinegar and baking soda, vinegar and castile soap aren't hazardous when combined, but the result will be an oily and expensive waste of ingredients. When combined, vinegar (an acid) and castile soap (a base) cancel each other and create unsaponified soap.
Some of the problems that can be caused by inhaling Pine SOL
However, the most common health problems are listed below: Irritation of the mucous membrane. Nausea and headache. Loss of consciousness.
You could spend big bucks on different cleaners for your furniture, toilet, floors, counters and appliances. With Pine-Sol® Multi-Surface Cleaner, you only need one cleaner to fight dirt, grime and grease, and deodorize all of these surfaces throughout your home. Easy for you, and easy on your wallet.
This multi-purpose cleaner has remained popular since the 1920s, and it contains glycolic acid as the key ingredient responsible for so many household purposes. This product is not as destructive as bleach, and it fights grime, grease, and dirt, leaving a fresh, pine fragrance.
First of all, the only hazardous ingredient listed on the Pine Sol MSDS is alkyl alcohol ethoxylates. These belong to a group of chemicals called "aromatic hydrocarbons" which are petrochemicals with strong, pungent, odors. The only health hazard listed on the MSDS is that it is an irritant.
“Never mix vinegar with other cleaning products like bleach or ammonia or those 'blue' window cleaning products [like Windex], because they can create dangerous chlorine gas,” Gayman says.
Despite the combination making for a good disinfectant, when combined, these common cleaning agents are a no-no. The acid in vinegar releases toxic chlorine and chloramine vapors when added to bleach. Beware of this combination causing chemical burns to your eyes and lungs.
Experts say this method is safe — but don't mix the two products in the same container. Combining them creates peracetic acid, which is potentially toxic and can irritate the skin, eyes, and respiratory system.
To make the solution is simple and easy on the wallet! Pour equal parts of vinegar and Dawn into a spray bottle. Gently shake, then spray liberally onto the surface to be cleaned. I have found the best results is when I use it to clean chrome shower and sink fixtures.
Soap Scum Remover: 1 part Dawn to 1 part Vinegar
If you have soap scum in your tub or shower, this duo is your new best friend. Add equal parts Dawn and vinegar to a spray bottle and shake gently to mix. If you have really tough deposits, you can heat the vinegar in the microwave before mixing for a little extra power.
Fill a wash-and-drain basin (like this one) with equal parts water and vinegar. Let your clean dishes soak in the vinegar-and-water solution for at least 30 minutes to ensure the microbes can't survive. Then rinse the dishes with water. And that's how you sanitize dishes with vinegar.
Dilute ¼ cup of Pine-Sol® in one gallon of warm water. Dip a sponge in the mixture to wipe grease and grime away. Or for everyday mess control, keep the Pine-Sol® mixture in a spray bottle for quick cleaning spritzes.
White distilled vinegar is the best vinegar for cleaning because it doesn't contain a coloring agent. Therefore, it won't stain surfaces. Staining can happen when cleaning with a darker-colored vinegar.
Steps For An Expert Clean
Clear shampoo, soap and other items from your shower so you can hit all the corners before you clean. Mix ⅛ cup of Pine-Sol® in ½ gallon of warm water. Wipe down your shower walls with the mixture. Use a sponge or fill a spray bottle with the mixture.
Pine-Sol® Cleaners are concentrated formulas that you can dilute for most jobs. For general cleaning, a 24 oz. bottle gives you 12 gallons of cleaning power! Add water to the formula yourself and save.