Use your toilet bowl cleaner and spray a minuscule line on the walls of your bathtub. Make sure you have your gloves on and use the scrub brush to scrub the walls and the floor of the bathtub. Use hot water from the spout to wash away the cleaner and soap scum.
Most toilet bowl cleaners are toxic because they contain chemicals that, while effectively removing stains and discoloration from the toilet, can be too harsh when used in the shower. This means that you should not use a toilet bowl cleaner in the shower unless you absolutely have to.
Sprinkle baking soda on all tub surfaces. For extra-dirty tubs, use tub-and-tile cleaner instead. Fill your bucket with a half-gallon of hot water and two tablespoons of dish soap. Dip a scrub sponge or a stiff nylon brush into the bucket, and scrub all bathtub surfaces.
Sprinkle some quantity of Borax onto a damp sponge. Scrub the entire bathtub with that Borax sprinkled sponge. Sprinkle borax directly on tough bathtub stains and scale to remove it quickly. Rinse your bathtub with cold water and there will be no grime, no scale, and now soap scum.
Heat one-fourth cup vinegar and pour into a spray bottle. Add one-quarter cup liquid dish detergent, and it give a little shake to distribute. That's it! The vinegar and dish soap work together to tackle soap scum and dirty tub rings.
The DIY toilet bowl cleaner works well in removing stains and leaves a fresh, clean odor in the bowl. Unfortunately, you'll still have to use a toilet brush and do a bit of scrubbing! But, as a bonus, you can use the mixture to freshen shower and sink drains and even remove soap build-up from the pipes.
Spray shower tiles with a commercial tile cleaner ($2, The Home Depot) or a mixture of equal parts vinegar and dish soap. Wait several minutes to allow the cleaning solution to break up soap scum and hard water deposits, then scrub with a soft-bristled brush and rinse well.
1. Can You Use Clorox Toilet Bowl Cleaner On Other Surfaces? Clorox Toilet Bowl Cleaner disinfects and removes tough stains which kill most germs and brighten the toilet. Examples of household chemicals you shouldn't mix with are other toilet bowl cleaners, rust removers, acids, or ammonia products.
Toilet Bowl Cleaner Used on Other Fixtures
Like drain cleaners, toilet bowl cleaner contains highly corrosive chemicals. The strong chemicals could damage or destroy the finish on your bathtub or other fixtures such as a sink, and can also damage grout.
No, you cannot use toilet cleaner in the shower. Toilet cleaner is for smaller areas like a toilet bowl. In addition, the chemicals used in a toilet cleaner can cause damage to your skin, emit toxic fumes, stain your grout, and damage your shower stall and plumbing fixtures.
Toilet bowl cleaners are often quite toxic and harsh smelling when confined to the bowl, but when applied to shower walls and tubs, the smell is amplified so turn on your exhaust and consider wearing a mask. Since the cleaner contains bleach, you should also use gloves.
Over time, the shower tiles and grout accumulate soap scum, hard water stains, grime, etc. Professionals apply a combination of warm water and liquid dish soap on the tiles and scrub with a brush.
As for your bathroom, be aware that toilet-bowl cleaners can harbor some of the most dangerous chemicals in your house. Products such as Lysol Power Toilet Bowl Cleaner Complete Clean contain hydrochloric acid, which can burn your eyes and skin.
The easiest way to thoroughly clean the toilet tank is to spray it down with a disinfectant cleaning spray such as Lysol or 409. Using a disinfectant spray will loosen much of the build-up, and kill most of the bacteria and germs.
Make a bathtub cleaner paste of one part hydrogen peroxide to two parts baking soda (or cream of tartar). Rub the paste on the stain and let stand for 30 minutes to one hour, then wipe and rinse. If necessary, repeat until the stain is gone.
Use a grout brush with hydroxipro if you detect any mold or mildew in the shower. Next we leave a small amount of bleach from a bleach pen behind. With the scratchy side of the sponge we layer Grip, a phosphoric acid cleaner, onto all shower walls and glass doors. Let sit at least one hour.
Once a week at least.
Tetro says your bathroom is the ultimate bacteria host; E. coli can be found within six feet of the toilet and in the sink. To keep it at bay, disinfect the toilet and sink at least once weekly, and the bathtub every two weeks — more if you shower often.
Hydrogen peroxide is an anti-fungal, anti-bacterial compound, making it an ideal cleaning solution for a shower stall. Use a plastic spray bottle to apply hydrogen peroxide to the shower evenly and efficiently.
In a spray bottle, combine 1/3 cup ammonia, 1/4 cup white vinegar, 1/2 cup baking soda, and 7 cups of water. Spray down the shower, then watch as the vinegar and baking soda together create a cleansing, bubbling foam. Let it sit for a few minutes, then wipe down the tiles and tub with a damp cloth.
Many toilet cleaners contain sodium hydroxide and sodium hypochlorite. These two ingredients help to remove stains and grime on porcelain or tile surfaces as well as grout. Though they can be toxic in large amounts, they do work to effectively clean grout.
Most kitchen and bathroom cleaners are interchangeable. The main active ingredients are either detergent (to cut grease), bleach (a strong alkaline to kill bacteria) or an abrasive agent (to scrub away built-up material). If your goal is to kill bacteria in the sink, then the toilet cleaner will work fine.
As with any cleaning product, some toilet bowl cleaners have harsh ingredients like bleach. This is beneficial if you're trying to remove tough stains and kill bacteria, but these chemicals can be dangerous if you have pets, kids, or a septic system.