Green or Dark Green Pool Water:
This means there's a medium amount of algae in your water and you'll need to triple shock your pool. Triple shocking requires 3 pounds for every 10,000 gallons of pool water.
You need to raise the level of your chlorine – shock the pool – and maintain that high level until all the algae is dead. This may take 3 to 4 days.
If you have a light green pool, you need to shock your pool in order to kill algae. Algae feeds off high pH levels and chlorine isn't as effective when your pH is high.
You cannot overshock a swimming pool or add too much. Adding too much shock or overshocking your pool will kill off algae. The negative of adding too much shock is it will upset the chemical balance of your pool.
If the pool is still very cloudy or green, you may need to shock it to make it safe to swim in again. First, make sure that the filter system is working properly and the chemicals are still at the proper levels. Next, mix up your chlorine shock (hyperchlorinate) treatment.
It's not a good idea to use pool shock at the same time as clarifier. Some clarifiers are polymer based and the shock can act to break up the polymer causing the clarifier to be ineffective. It's best to shock your pool before and wait a day or two before adding clarifier.
Algaecide should be used after each shock treatment, so it has a better chance to support your chlorine as it works its magic. Be sure to shock your pool first, then when the chlorine levels of your pool return to normal, add the correct amount of algaecide to several places around your pool while your pump is running.
Keep your pump and filter running. Give the shock a good 12 to 24 hours to work it's magic. If the algae hasn't cleared up after 24-48 hours, clean and brush the pool and add another shock treatment.
Pools can immediately turn green after shocking when they have metals like copper or iron in the water. These metals oxidize when exposed to high levels of chlorine which makes the pool water turn green. Metals in the water are caused by some algaecides and using well water.
When the levels are properly balanced, chlorine will keep the algae at bay, but the water will slowly begin to turn green as the algae take over if there's not enough. But be careful—adding too much chlorine in pool water can cause those metals to oxidize and turn the pool a different shade of green.
A pool filter should be run for a minimum of 6 hours after shocking a swimming pool. This is to allow the filter to clean the water and give the shock enough time to fully mix with the pool water. Running the filter after shocking for 24 hours to 7 days is necessary if the pool has a large amount of algae.
Causes of Rising Alkalinity
It's also not uncommon for pool owners to go a bit overboard when shocking their pool, and since chlorine-based pool shock is a high-alkaline substance, it will also naturally raise your pool alkalinity.
How long after putting shock in pool can I add clarifier? 8) How long after adding chemicals can I swim? Alkalinity Balance, pH up, pH down, Calcium Balance, Water Stabilizer, and clarifier are all swim-safe chemicals. Wait about 20 minutes, and you are free to swim.
While shocking and adding algaecide is effective in getting rid of algae, it should not be done together. This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.
Neither will chlorination be effective with a diffuser and without a pump. The best thing to do is to apply liquid chlorine in the pool. Then, you have to circulate the pool manually with the use of a telescopic pole or paddle. This will ensure the chlorine disperse well.
In theory, if you have a cloudy swimming pool, you can add chlorine to “shock it” and clear things up. Chlorine will get the job done. But, the amounts may vary and you may have to really pound the pool with chlorine to get the water totally clear.
Typically for granular shock, you'll need one pound for every 10,000 to 13,500 gallons of pool water.
Are chlorine and shock the same thing? SKIMMER NOTES: No. Chlorine and shock are not the same thing. Shock has a more intense chemical strength than the traditional chlorine sanitizers, and it also differs in how you should apply it to your swimming pool.
It's pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn't be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.
How Often Should I Shock My Pool? Shocking your pool regularly will help to keep the water clean and free of contaminants. You should aim to shock your pool about once a week, with the additional shock after heavy use. Some tell-tale signs that your pool needs to be shocked are cloudy, foamy, green, or odourous water.
The use of baking soda in pools can spot treat algae
No one ever wants to see algae build up in their swimming pool. It can turn any backyard pool murky green or cause unsightly black spots on the walls and floor of any swimming pool.