A second flush will only create another disaster, in addition your current problem. Remember: don't flush again! Here are a couple solutions to fix your clogged toilet. All solutions will effectively get rid of the clog, but take various amounts of time and effort to get rid of the clog completely.
You should never flush a clogged toilet more than once. Instead, take the lid off the back of the toilet and close the flapper. This will prevent any more water from running into the toilet bowl while you're working.
Check water level in toilet bowl
After plunging for thirty seconds, quickly break the seal and remove the plunger. Listen for a gurgling sound from the drain (a good sign) and check the water level in the toilet bowl. If nearly all the water drained from the bowl, then you've probably cleared the clog.
Will a toilet eventually unclog itself? It sure would be nice, but it's fairly rare for a toilet's clog to clear up after a few hours. It can happen, but only in select circumstances. Here's what you need to know about whether your toilet will unclog itself.
It could be a non-flushable item, too much toilet paper, or simply excess waste. If your toilet constantly clogs, there's a reasonable chance that the S-trap has a lot of matter stuck inside. Unclogging the S-trap may be the answer to why your toilet clogs easily. Plunging should move most clogs along.
You may just be using it incorrectly. Do this: Next time you have a clog, use your plunger like this: Ensure the flange lip is unfolded. Get a good seal on the toilet drain (that is, make sure you're covering the entire drain or you won't have enough pressure to loosen the clog.)
Hot Water and Dish Soap
Wait for 10-15 minutes while the dish soap and hot water soften the clog. Once you do so, the toilet will unclog and flush freely. Alternatively, you could use hot water and shampoo from the sink if you wish to clear your toilet without leaving your bathroom.
Using too much toilet paper
This is probably the most common reason toilets get clogged — and often the easiest to deal with. If we're honest, most of us are probably guilty of this one. If you're one of the many people who use a lot of toilet paper when you use the bathroom, here are a few tips!
Attempting to force a clog through a toilet with a plunger can often make the problem worse. Instead, create a seal and slowly push down on the plunger before pulling it back sharply. The suction can help pull the clog back up toward the bowl, breaking the blockage and allowing gravity to take over.
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water. For tough problems, allow 30 minutes before flushing.
You may have a first-generation, low flow design. The low flow design was created to help homeowners save on water, but the earliest models ended up lacking the necessary pressure to properly clear the internal trap and drain. In other words, this means that it can continuously become clogged if you aren't careful.
Maybe. If your toilet is constantly clogging, the problem could be the toilet itself or it could be something else entirely (like a sewer or septic line problem). So before you rush off to purchase a new porcelain throne, make sure the toilet is really the problem...
Bleach is an effective way to deal with blocked toilet drains as it is a dilute solution of sodium hypochlorite and also contains a high chlorine concentration. Using bleach by itself or mixing it with boiling water are effective ways to unclog a toilet.
You might want to see if the clog works itself out in time. If you have another toilet you can use, let the clogged one set overnight. The water pressure that builds up in the bowl might actually cause the toilet to unclog itself. After a day's wait, flush the toilet again.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Plunge-in well:
The plunging process needs to be down slowly; operating anything by force will ruin the bathroom with water. After the primary gentle plunge, forcing the air out they dig into plunging in and out strenuously, keeping the seal intact, for 15 to 20 times until most of the clogs are not unclogged.
Can you leave baking soda in the drain overnight? It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain.
Preventative Maintenance
Pouring bleach into the drain when the unit is not operating can leave residual bleach, which will damage the drain pan and line. Using vinegar for preventative maintenance throughout the year will keep your drain clean and clear and will not damage your line.
You can also pour vinegar down the drain on its own.
Pour about 1 cup of vinegar down your drain and let it sit for 30-40 minutes.
In this scenario, squeezing liquid hand soap, body wash, or shampoo into the toilet should net you the same results. STEP 2: Let the soap sit for about 20 minute so it can coat and loosen the clog for maximum flushability.
While you can use a regular drain snake in a toilet, a closet auger, or toilet auger, is a type of drain snake specifically designed for use in a toilet. Its unique design and protective rubber coating allow it to maneuver through the tight S-bend in a toilet without damaging the porcelain.