The light on the fridge is not actually connected to the filter; it works on a 6-month time frame; so when you change the filter, the light may remain on.
you have to press and hold the reset button for about 10 seconds to reset the filter light. The unit doesn't know if you change the filter or not, you have to press and hold the button to let the unit know you changed it. If it won't reset then you will need to replace that display board behind the button.
After you change the filter, you must press and hold the RESET WATER FILTER pad until the red light goes off. The light will either disappear or turn green. If you do not hold the pad in, the red light will stay on. Also, if you hold the pad in for a long period of time, the light may go off and then come back on.
Locate the reset button, usually found beneath the status light on the control panel. Press and hold the button for three seconds or until you hear a beep or chirp. Once the appliance makes a noise, you can release the button and close your fridge.
How do I reset the filter light? After you change your filter, the “Check Filter or “Check Pre-Filter” light will remain on until it is reset. With the unit powered on, press the lighted button, and hold for approximately 2 seconds until the light turns off. The electronic filter check is now reset.
The Filter light turns red to let you know when it is time to change your water filter cartridge. To give you time to get a new filter the red light comes on just before the capacity of the current filter runs out.
How to reset the red filter light indicator? To reset your filter timer and get rid of the red light after replacing the filter, press the Fan button for 15 sec until the red light turns off.
It doesn't seem to cause any issues. It may surprise you, but the answer is yes, if the refrigerator or any appliance has a filter, it needs to be replaced according to the manufacturer's specifications.
You can reset the ice maker in many refrigerators by simply turning it off for a minute and then turning it back on. Refer to your fridge owner's manual for instructions on turning off the ice maker in your model.
Run two to four gallons of water through the new filter. This helps prevent your water dispenser from sputtering and clears impurities left over from manufacturing. Check for leaks around the filter.
GE/Hotpoint/Sears(363. series) - press and hold the reset water filter button for 3-5 seconds. Maytag/Jenn-Air - press and hold the lock and light buttons OR lock and water buttons until the indicator light blinks.
Unplug your refrigerator
Disconnect your fridge from its power source by removing the power cord from the wall outlet. You may hear some whooshing or knocking noises after you do so; that's normal. Make sure your fridge stays unplugged for several minutes, otherwise the reset won't work.
The most common issues that GE refrigerators face include water leakage from the ice maker, temperature control issues, and excessive noise. Fortunately, many of these problems can be fixed easily with a few troubleshooting tips.
Refrigerator - Water Filter Indicator Light Will Not Shut Off. Refrigerators with a water filter often have a reminder to change the filter. This reminder can be time based or water usage based, or both. Depending on your model, you must reset the reminder manually, or the reminder resets automatically.
After cleaning the filter, plug the unit back into the power source and reset the filter by pressing the 'Filter Reset' button and the light will go off.
If you see a Filter button on the refrigerator, push and hold this button for 5-10 seconds. LG - push the Reset button and hold it for 3 seconds. Samsung -push the Child Lock and Ice Type buttons at the same time and hold for 3 seconds. (Do not hold the buttons longer than 3 seconds.
No Filter | Bad or Damaged Filter | Wrong Filter | Non-GE Filter. "ERR" will be displayed in the control.