The battery is too low to lock the door. This is indicated by the Checkmark and Lock symbols flashing simultaneously five times with five beeps. Remove the batteries and replace with a fresh set. The mounting plate is placing tension on the torque blade.
Check that the bolt hole is at least 1” deep so the bolt fully extends. Check that the door closes properly so that when the deadbolt is extended, it is going into the bolt hole and not hitting the deadbolt strike or door frame. Check that the mounting screws securing the exterior keypad are not over-tightened.
Try rebooting the door lock by removing the batteries. Removing the batteries will force the device to reset. Then, check the security panel (or control panel) to make sure that the door lock is appearing on the list of connected devices. If it is not appearing, reconnect it.
No user codes are programmed. If there are no codes in the lock, the lock button will not lock the door. This is indicated by the keypad flashing red three times with three beeps. Program at least one user code and test the Lock button again.
Here is what usually causes a Kwikset lock to not work after a battery change: Batteries Incorrectly Installed. Dirty or Corroded Connections. Technical Glitch in the Lock.
How do I know when the batteries are running low on my Smartclode 909/910 deadbolt? There are two low battery indicators on the unit. The LED light on the interior side of the lock will flash red when the batteries are low. The keypad will also flash red when the batteries are low.
The lock should beep twice when it unlocks and once when it locks. It will also beep if there is a warning such as a low battery or a jammed bolt.
Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3. Press the Program button once more. When the LED flashes green and you hear two beeps, the lock has been reset.
Door lock problems are often caused by a malfunctioning lock mechanism or latch assembly, but there are several common reasons why locks stop working: The lock is dry or dirty. It doesn't fit in the door properly. The latch and strike plate don't align.
Sometimes a door lock mechanism may not work simply because it's dirty or needs to be lubricated with graphite (do not use any type of oil because this will gum-up the works). An improperly functioning door latch may be the result of a poorly fitting door.
Smart locks can be much more expensive than conventional lock-and-key systems. Our smart locks occasionally may not work properly when we try to sync them with other devices or connect them to our cell phones. Weak WiFi or a network issue may be one cause of this.
Replace batteries with new ones to ensure that lock is properly powered. Typical battery life based on 10 entries per day is 10-12 months if the door is properly aligned and the lock does not encounter interference in lock/unlocking the door.
On my Smartcode 888, the lock button flashes red with fast beeping sounds for three to four seconds. This is a low battery alert. Please replace you batteries.
The battery is too low to lock the door. This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.
If your Electronic Door Lock is beeping and the buttons are flashing red, this means that there's been some kind of error or the batteries are low.
What Do The Different Colored Lights On The Status LED Mean for my Premis Lock? Amber flashes mean it is locked, while green flashes mean it is unlocked, and red means low battery.
No, user codes will not be lost if the batteries die or are removed.