You probably need to reset the spring inside. Take it out and roll it up by hand, turning the entire roll in your hands, secure the ends and pull it down, repeat several times, the internal spring should have enough tension to respond to a tug by rolling UP the shade while mounted.
Below are some of the most common problems and their causes: Blinds refusing to roll up or down: Often caused by a misaligned or jammed roller mechanism due to dust, debris, or wear and tear. The tension spring inside the roller tube may also lose tension, causing uneven rolling.
The first thing to try is to take hold of the bottom of the blind by the bar, and gently pull it downwards until the fabric has un-rolled to its full extent. If this works, then just re-roll the blind back up again slowly and gently, while taking care to ensure that the fabric rolls evenly and not on a wonk once more.
Blinds that won't lift may have a worn-out spring mechanism or one that is locked in place. Remove the blinds from the window and place them on a flat surface. Look for the pin that controls the tension and carefully twist it clockwise to increase tension.
If the roller shutter falls down by itself, this means that one of the components of the mechanism is damaged. Most likely the chain mechanism, responsible for raising the fabric, or the roller (the material is wound onto it) is damaged. There may also be damage to the fastening system, guide or cassette.
If the sprung pin is full compressed and the bracket is touching the barrel of the blind, it will act as a brake. This will make the mechanism stiff to operate and this often indicates that the brackets have been fitted too close. The easiest fix is to try to bend the bracket away from the barrel slightly.
Misalignment often causes blinds to stick or jam. If your blinds aren't raising or lowering evenly, carefully remove them from the window and lay them on a flat surface. Check for any slats that may have become disconnected from the lift cord.
After lowering your blinds to the desired level, it's time to lock them in place. To do this, gently pull the string at a 45-degree angle to the right. You should feel and hear a click when the clutch locks into place. Don't tug, but make sure to give the string a firm tug, so your blinds stay in place.
You probably need to reset the spring inside. Take it out and roll it up by hand, turning the entire roll in your hands, secure the ends and pull it down, repeat several times, the internal spring should have enough tension to respond to a tug by rolling UP the shade while mounted.
The small blind is placed by the player to the left of the dealer button and the big blind is then posted by the next player to the left. The one exception is when there are only two players (a "heads-up" game), when the player on the button (the dealer) is the small blind, and the other player is the big blind.
This is usually caused by a failed cord lock or crushed cord. To determine if the problem lies with the lock or the cord, do this: Try to raise your blind up just a few inches and lock it in place. If it locks, the problem lies with the cord. If it doesn't lock, the problem lies with the locking mechanism.
Try lowering the shade completely, then raising it to allow it to self-correct. If one of the lifting strings is frayed or broken you will need to replace all the strings in that operation.
Why are my motorized blinds not responding to the remote? Common reasons include dead batteries, signal interference, and physical obstructions. Ensure the batteries are fresh, there are no other electronic devices causing interference, and there's nothing blocking the blinds' movement.
Re-adjust the tension
The issue you are having could be down to a lack of appropriate tension. To fix this, remove one end of your cordless roller blind from its bracket. Spin the blind one way while ensuring the spring stays within the bracket. You will increase the tension and get it back to a suitable state.
Ensure the blinds are plugged in or the power source is functioning correctly. Sometimes, a loose plug or power interruption can cause the blinds to stop working. Verify that the remote is working. If it isn't, try replacing the batteries or using a different remote to rule out any control issues.