On top-loading machines, your filter is likely under the panel on the bottom right of the front of the machine. On a front-loader, the filter is probably behind the dispenser drawer. If you can't find your filter on an older model, remove the back panel and look underneath the drum for it.
Top-loading washing machines usually have a drain filter hidden behind a flap visible on the front side of the machine casing (example 1), or hidden in the threshold of the drum (example 2 - in this case the threshold of the drum has a special recess that allows it to be lifted up).
Regularly cleaning the filter pump on your Whirlpool front load washer is important for maintaining peak performance and extending the appliance's lifespan. A clean filter pump helps prevent clogs and ensures your washer operates efficiently.
Locate your water filter cover in the upper right-hand corner inside your refrigerator or in the base grille. Lift the filter door up. Pull the filter out and discard it. Open your new filter and remove the protective coverings from the O-rings.
Most top load washers made after 2001 do not have washer filters in their drainage system. Instead, newer models utilize a more powerful drain pump and larger drain holes.
Usually, if the drain pump isn't working properly, you'll hear an unusual noise or notice leaking from the washing machine when it is running. If your pump is malfunctioning, you'll need to replace it yourself or call a professional to replace it for you.
Find the drain hose
Your machine will either have one drain pump filter by itself or a drain pump filter with a separate drain hose. In either case, these will be behind a panel on the front of your machine.
Most front-load washers have the filter behind a small panel on the bottom front of the machine. Look for a designated access panel, often hidden behind a kickplate or covered by a cap. Top-load washers often have the filter inside the machine, accessible through the agitator or under a panel in the back.
Washers can stop draining for a variety of reasons. If your washer won't drain or spin, it may be a problem with the lid switch. If it works normally aside from not draining completely, it may be a clogged drain hose or pump.
On top-loading machines, your filter is likely under the panel on the bottom right of the front of the machine. On a front-loader, the filter is probably behind the dispenser drawer. If you can't find your filter on an older model, remove the back panel and look underneath the drum for it.
If you're looking for a top load washer, probably GE has the strongest drain pump since it's a turbine pump and not just a plastic pump that attaches to the shaft of the motor or a small pump that mounts to the side of a reservoir like the 300BW you're considering.
Disconnect the hose from the machine and use a wire hanger or plumbing snake to remove any debris or buildup. After cleaning the drain hose, reconnect it to the washing machine and run a cycle to make sure everything is draining properly.
Clothing That Feels Heavy After a Cycle: When your clothes are unusually damp even after a spin cycle, it's a sign that the machine isn't draining effectively, which usually points to the filter! Water Leakage: Unexpected puddles around your washing machine might indicate pressure buildup caused by a clogged filter.
“The drain trap is typically located at the bottom of the washing machine, near the drain hose, and is designed to prevent lint and debris from entering the plumbing system and causing blockages or damage,” says Smith.