For the most accurate temperature readings and energy efficiency, install your thermostat on an interior wall in a frequently used, central room. Mount the device exactly 5 feet (60 inches) above the floor, and keep it away from direct sunlight, drafts, and heat-generating appliances.
Avoid placing a thermostat in areas with abnormal temperature fluctuations or poor airflow, such as in direct sunlight, above supply vents, near exterior doors or windows, and in kitchens. Instead, mount it about 5 feet above the floor on an interior wall in a frequently used, central room.
Millivolt thermostats are the most common type used for gas fireplaces while 24 volt thermostats are common for furnaces or boilers. When the room temperature falls below the thermostat's set temperature, the IPI module triggers the gas fireplace to ignite, increasing the heat output.
Yes, thermostat placement matters significantly. Your thermostat acts as the control center for your home's HVAC system. If it is placed in an area with abnormal temperatures, your heater or air conditioner will run inefficiently, leading to uneven room temperatures and higher energy bills.
Yes, 72°F is a very comfortable temperature for your daytime heat setting. However, it is slightly higher than the recommended energy-saving guidelines, which could increase your heating bill.
While everyone has a different tolerance to cold, ideal winter heat settings should generally be at or above 63 °F (17 °C). Excessive cold (anything below 62 °F or 16 °C) in your home can actually raise your blood pressure as your blood “thickens” in the chilly temperatures.
It takes time for your home to warm up and cool down. If you're not sure how long it takes, try turning the heating on about 30 minutes before you need it. You should turn it off 30 minutes before you'll stop needing it.
The hall is the wrong place for the room thermostat, it should be located in the room you spend most of the time, usually the lounge. If installed in the lounge, thermostatic radiator valves will need to be removed, if fitted.
No, it is generally not cheaper to leave your heating on low all day. According to the U.S. Department of Energy, maintaining a constant temperature results in continuous heat loss, causing your system to consume more overall energy.
The cheapest temperature to keep your house in winter is 68°F (20∘C20 raised to the composed with power C𝟐𝟎∘𝐂) while you are home, and lowering it to 61°F–65°F when you are away or sleeping, according to the Department of Energy. Setting your thermostat back 7°–10°F for 8 hours can save up to 10% a year on heating costs.
Further, most digital thermostats are compatible with most gas fireplaces, so it isn't likely you'll have to worry about a model not working with your fireplace.
It's most likely your vents. You should have a lever or flaps you can close, when not in use that is. If your fireplace is so old that it is doing it because it is a draft issue from the venting, your unit probably needs replaced because of that age and use.
Explained, the chimney pipe must be a minimum of three feet above the roof but also two feet taller than anything within ten feet. The portion of the rule stating the pipe needs to be 2 feet above anything within 10 feet is where most people get confused.
We would not advise putting the thermostat in the coldest room as this would not be a true reflection of the temperature of the rest of the house. You want an average reading for it to work efficiently so placing it in the coldest part of the house would be an extreme cold air temperature zone to avoid.
Four Thermostat Do's and Don'ts to Save Money
Install your thermostat between 52 to 60 inches above the floor on a central interior wall. This standard "eye-level" height prevents drafts from affecting the temperature sensor and keeps the unit out of reach of small children.
The single biggest energy waster in a house is heating and cooling (HVAC), which accounts for roughly half of a home's total energy consumption. The main culprit is conditioned air escaping through poor insulation, leaky windows, and drafty doors, forcing systems to work overtime.
Known for his practical tips, Lewis introduced the '4pm rule' which involves using curtains strategically to retain heat. He suggests opening curtains when the sun rises at around 8:30am to let in natural warmth, and closing them by 4pm to keep the heat inside.
Typically, a furnace should cycle 3 to 8 times per hour, running for about 10 to 15 minutes each time. If it's cycling more frequently (short cycling) or running for 20+ minutes straight regularly, something's not right.
3 Places You Should Never Install a Thermostat
If you have a hallway radiator, just try turning it off for a day or two and leave the doors open to the hallway. You'll soon find that all of the heat from the other rooms begins to make its way to the hallway.
In the summer, set the thermostat two to four degrees lower than what you would like the upstairs temperature to be. This will allow the cooler air upstairs to drop to the lower floor. During the winter, set the thermostat two to four degrees higher than what you would like the downstairs temperature to be.
In most homes, Heating and Cooling (HVAC) systems drive the highest energy costs, accounting for nearly 40% to 50% of your total electricity bill. Following these, the appliances that run up your bill the most include water heaters, refrigerators, and laundry machines.
Heating and energy expert Stephen Hankinson said that one "big energy cost saver" is to make sure you have your heating off when you're not at home. For instance, if you typically arrive home from work at around 6pm on weekdays, you could set your heating to activate just as you walk through the door.
For most customers, we recommend turning on your furnace when the weather is consistently below 18° Celsius, which usually happens to be around the end of September, or early October. Some homeowners try to put off turning on their furnace as long as they can to save money, which is okay if you're healthy adults.