For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The "Filter" setting is used for light to moderate levels of pool sediment.
8. Vacuuming pool with filter valve in "backwash" position. When a pool is vacuumed with the sand filter valve in the "filter" position, the dirt and debris that passes through the pump ends up inside the filter on top of the bed of sand which is where you want it.
Start at the shallow end and then work your way to the deep end of the pool. Once you've vacuumed it once, you'll need to grab a brush and scrub away at your pool's floor. Then vacuum it again. Repeat this until the bottom of your pool looks clean.
For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The "Filter" setting is used for light to moderate levels of pool sediment.
If dirt is reappearing at the bottom of your swimming pool after you've vacuumed it your pool's filter may be working poorly. Pool filters often work poorly because they're in need of cleaning. If you have a sand filter for your pool you need to make sure that the sand is sharp and freshened up.
Connecting the vacuum system to the pump.
Now, here answers the question earlier: do you leave skimmer basket in when vacuuming pool? YES, you need to remove the skimmer or strainer basket before attaching the open end of the hose to the inlet. Finally, plug the open vacuum hose into the suction port.
The most common connection locations are the open skimmer, suction port, or filter. An automatic pool vacuum system uses the pool's natural filtration system to clean it, so it could hook up to several ports since the entire pool uses the filtration system.
Rule out the obvious causes of poor vacuum first. Make sure the water level in the pool is sufficient and air is not being sucked in through skimmer inlets. Add water to the pool to submerge the skimmers if necessary. Verify that the pump strainer basket and the skimmers are free of debris that may obstruct water flow.
Fine debris such as dust, sand and dirt is carried into a pool on the feet of swimmers or on the breeze. While a skimmer removes larger items such as leaves or insects, fine matter drifts to the bottom of the pool and forms a layer of sediment.
Use A Pool Vacuum
To get rid of all the sediment on the pool floor, you vacuum it up! Using a manual or automatic pool vacuum (robotic, suction-side, or pressure-side), you can easily suck the dirt off the bottom of the pool.
Yes, we recommend backwashing after you vacuum your pool. This allows the filter to shoot out any dirt / debris you have vacuumed up. Don't forget to set your filter to “rinse” for 30 seconds after backwashing!
Depending on the type of surface in your pool, you can use a brush to scrap it clean with or without water in it. If the pool has a soft vinyl liner, you will use a rubber or nylon brush to keep it clean. If the pool has a concrete floor and walls, a stiff and course brush will do the trick.
If there is air in the pump basket, that might indicate a suction side blockage. This could occur anywhere between the pump and the skimmer. This is also indicated by a drop in filter pressure from the normal condition.
Backwashing is a pool term used to describe a filter cleaning method which reverses the flow of water through your filter system.
On the skimmer there should be a fitting where the hose will connect. Loosen the clamps that came with the filter and slide them over the hose ends. Install one end of the hose onto the skimmer fitting and tighten the clamp. It should be pushed on tightly.